Disco 1 Looking for a camel cut guide

philreed52 · Nov 12, 2016

Evening all, spent an age searching for a camel cut guide and it's stressing me out.. does anyone know where I can find it? I'm just about to do mine but I wanna make sure I'm prepared beforehand....

Cheers

Critical Mick · Nov 13, 2016

philreed52 · Nov 13, 2016

Thanks for your reply, it was moreso the rear doors that I'm looking for

Cheers

RichardH · Nov 14, 2016

philreed52 said:
Thanks for your reply, it was moreso the rear doors that I'm looking for

Cheers

Camel cut is just a slight cut on the rear quarter. Cutting the rear doors is normally only done when you are fitting flexi arches.

philreed52 · Nov 14, 2016

Aah ok thanks for your help guys. I'll see if I can find anything under fitting flexi arches cus that's what I'll be doing

StuRox · Nov 15, 2016

just tape on the flexi arches, mark and cut away the metal for them to fit - only tip is be cautious when cutting - better to cut off a little, than too much.

You will be surprised how much metal you actual cut away - I was

philreed52 · Nov 15, 2016

Thank you for your replies! I'm gonna fit the flexi arches as soon as I get them. The underside is in fairly good condition to be fair but next summer I'm gonna take off both rear quarters, cut the sills out and replace with box section and replace the pillar boots. I wanna get the whole thing as rot free as possible then treat it

Disco 1 Looking for a camel cut guide

philreed52

Member

Critical Mick

Member

philreed52

Member

RichardH

Active Member

philreed52

Member

StuRox

Well-Known Member

philreed52

Member

Similar threads