L322 LCD Pixel repair

I am in the need to sort out the dead pixels on my landy and i have found that is just the ribbon thats dodgy so done a bit of looking around and found the ribbon but i'm not sure if it is the correct one, can someone have a look at the ebay link for the ribbon and tell me if it is correct or not and if it isn't could you point me in the right direction.
Thanks
http://www.ebay.co.uk/itm/17cmx2-5c...sh=item419b484c5b:g:swAAAOSw9N1V1Y3l#shpCntId

Sorry i cant tell you but if it involves removing the needles you can brick your cluster if you get it wrong.
i had mine repaired at the link below but i am not sure if they are still at this address, it cost me £99 and they have been fine for around 3 years now
http://www.cartronix.co.uk/manufacturers/category/36-land-rover

I want to do mine too! So I can read that TRANS. FAILSAFE PROG. more clearly haha!

Yes you have to remove the speedo needles...and that is the tricky part!! Thre rest is quite simple.

I can't remember exactly what is was called, but is was something like the 'Silver track Clear one' or something like that....the cheaper Chinky ones are no good.

I repaired one using kit from these people. http://www.akspeedo.com/range-rover-lcd-pixel-repair-shop.php

Make sure you also buy the Speedo Needle Removal tools. You can do it without but it's really fiddly, and required drilling the plastic. With the needle tools, you can get the needles off without breaking the motors, and the LCD fix is then quite easy.

pwood999 said:

I repaired one using kit from these people. http://www.akspeedo.com/range-rover-lcd-pixel-repair-shop.php

Make sure you also buy the Speedo Needle Removal tools. You can do it without but it's really fiddly, and required drilling the plastic. With the needle tools, you can get the needles off without breaking the motors, and the LCD fix is then quite easy.

Click to expand...

Thanks for that, looks like they are the ones to go with, will definitely get the removal tools

pwood999 said:

I repaired one using kit from these people. http://www.akspeedo.com/range-rover-lcd-pixel-repair-shop.php

Make sure you also buy the Speedo Needle Removal tools. You can do it without but it's really fiddly, and required drilling the plastic. With the needle tools, you can get the needles off without breaking the motors, and the LCD fix is then quite easy.

Click to expand...

Apologies for dragging this one kicking and screaming back to life but when you replaced the needles did you recalibrate or do you have to try to get them back in the same orientation that they were removed in? I am about to undertake this fix and was curious about the resetting of all the needles. Its on an 02 plate.