LANDROVER 2 TD5 WONT START NO IMMOBILIZER LIGHT NOT FLASHING

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

MALOCK

Member
Posts
14
Location
yorkshire
Hi all just got back from holidays and battery has gone flat Charged battery and Landrover wont start turned key and nothing also key fob not working had to unlock by key nor will the indicators work... no flashing immobilizer light on dash? :(
 
Last edited:
Have fully charged battery when i turn the key dash lights up but nothing else happens there is no immobilizer light flashing...
 
MALOCK said:
Have fully charged battery when i turn the key dash lights up but nothing else happens there is no immobilizer light flashing...
Click to expand...

You won’t have the flashing led, as soon as you unlock remotely or have the key in the ignition lock the led illumination will disappear, meaning the engine has been remobilise... usually.
Your issue appears to be the engine won’t crank... correct?
 
discool said:
You won’t have the flashing led, as soon as you unlock remotely or have the key in the ignition lock the led illumination will disappear, meaning the engine has been remobilise... usually.
Your issue appears to be the engine won’t crank... correct?
Click to expand...
Charged battery and Landrover wont start turned key and nothing also key fob not working had to unlock by key nor will the indicators work... no flashing immobilizer light on dash? :(
 
Don't you have to reinitialise or something in these circumstances? Don't know enough about it but seem to remember reading somewhere it is something to do with pressing the lock unlock fob over and over again until it all starts to work. @sierrafery will tell you I expect as he has more electrickery brains than me. Also have you tried locking and unlocking the door with the key at least 3 times? Elsewhere I have read says it could be the BCU maybe damaged when playing around with the started motor, did you do any of that? Did you disconnect the battery and then reconnect it properly when recharging it, respecting all the time constraints in the manual. did you recharge it without disconnecting it? All connections to Starter tight?
 
Stanleysteamer said:
Don't you have to reinitialise or something in these circumstances? Don't know enough about it but seem to remember reading somewhere it is something to do with pressing the lock unlock fob over and over again until it all starts to work. @sierrafery will tell you I expect as he has more electrickery brains than me. Also have you tried locking and unlocking the door with the key at least 3 times? Elsewhere I have read says it could be the BCU maybe damaged when playing around with the started motor, did you do any of that? Did you disconnect the battery and then reconnect it properly when recharging it, respecting all the time constraints in the manual. did you recharge it without disconnecting it? All connections to Starter tight?
Click to expand...
Thank you for the reply its looking like the The Body Control Unit that is damaged i am now looking in to how to remove etc to see if it is water damaged as i have had a damp issue on drivers side foot well water getting in some where...
 
Don't mess with the BCU as long as you dont have dedicated tester cos it's useless, check fuse F20 under the dash, if it's good remobilise the vehicle with the EKA code and replace the roof receiver for start...if you dont know the EKA code you are ph*cked.... NO NEED TO YELL THOUGH :rolleyes:
 
sierrafery said:
Don't mess with the BCU as long as you dont have dedicated tester cos it's useless, check fuse F20 under the dash, if it's good remobilise the vehicle with the EKA code and replace the roof receiver for start...if you dont know the EKA code you are ph*cked.... NO NEED TO YELL THOUGH :rolleyes:
Click to expand...
I am just trying to upload a video now i have taken of my husbands car,... It has a b with a line through flashing on dash.
 
Stanleysteamer said:
Don't you have to reinitialise or something in these circumstances? Don't know enough about it but seem to remember reading somewhere it is something to do with pressing the lock unlock fob over and over again until it all starts to work. @sierrafery will tell you I expect as he has more electrickery brains than me. Also have you tried locking and unlocking the door with the key at least 3 times? Elsewhere I have read says it could be the BCU maybe damaged when playing around with the started motor, did you do any of that? Did you disconnect the battery and then reconnect it properly when recharging it, respecting all the time constraints in the manual. did you recharge it without disconnecting it? All connections to Starter tight?
Click to expand...
Don’t confuse the OP... pressing the lock button is a D1 function when the fob or vehicles battery is disconnected and reconnected. ;)
 
This is what is new on the dash?
 

Attachments

  • STA73455.JPG
    STA73455.JPG
    161.5 KB · Views: 198
You must log in or register to reply here.

Similar threads

Andrewoldold
M&S lights no crank / potentially immobilised?
Replies
1
Views
229
sierrafery
sierrafery
S
1993 discovery alarm
Replies
4
Views
511
Scott120160
S
loonyspoony
Disco 1 300TDI No Start
2 3
Replies
41
Views
2K
loonyspoony
loonyspoony
C
D2 2004 td5 no start immobiliser
Replies
1
Views
757
Chips666
C
G
Td5 central locking (another one)
Replies
3
Views
792
sierrafery
sierrafery
Back
Top