Happyhippo
Active Member
- Posts
- 122
hello all, been a while since I posted. I've been busy! Fitted new engine and the hippo is working well, and I'm happy again! A few minor issues like fitting new clutch hydraulics which appeared to need bleeding and blowing off the turbo hose but I can cope with these.(I saw a post on here which talked of allowing air to rise in the pipe work and allowing it to bleed out naturally. It worked for me!)
Trouble is now that it's warmer I could do with the Aircon working again. Everything is refitted but before I recharge the system, I bought a new receiver/drier. When I tried to fit it, I found that the thread for the pressure sensor is different from that in the existing accumulator. I have two new accumulators both bought for 2000my XEDi and both have the same sensor thread but different from the original. I wouldn't mind buying a new sensor if I could be sure it would fit and work.
I'm no expert with Aircon but just tried to ensure everything is clean and gas tight. Also I wondered about just recharging system without renewing accumulator? Or even warming up it up in the oven to try to dry it out.
Any help would be much appreciated.
Happyhippo
Trouble is now that it's warmer I could do with the Aircon working again. Everything is refitted but before I recharge the system, I bought a new receiver/drier. When I tried to fit it, I found that the thread for the pressure sensor is different from that in the existing accumulator. I have two new accumulators both bought for 2000my XEDi and both have the same sensor thread but different from the original. I wouldn't mind buying a new sensor if I could be sure it would fit and work.
I'm no expert with Aircon but just tried to ensure everything is clean and gas tight. Also I wondered about just recharging system without renewing accumulator? Or even warming up it up in the oven to try to dry it out.
Any help would be much appreciated.
Happyhippo