Intermittent Fault

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Nichol71

Nichol71

Member
Posts
26
Location
Banbury
Hi all, I hope you're all keeping safe in these unusual times.

I've had my 04 Disco 2 Landmark for about 12 months and have a problem that is bugging me. After having the usual teething problems of ball joints, fuel pump, welding the chassis, new wiring loom from the pedal to ECU, new auto gearbox!! etc I can't seem to solve this one.

Under accelleration she sometimes cuts out but then bursts back into life as if nothing is wrong and it may not happen again on that journey but on the next it will do the same. Some journeys are worse than others but there doesn't seem to be any pattern. I've plugged in my Hawkeyes but have no faults recorded.
Any ideas? Cheers
 
Good afternoon, an update on the fault.

I checked the pipe work and all seems well. I can't see any obvious breaks in the cables and the modulator doesn't look that old but I fitted a new one anyway.

The fault was still there on a run so I removed the F2 fuse which made the power loss worse. Still no faults recorded on Hawkeye.

Any more ideas?
 
From now you nreally need to plug in a diagnostic tool... did you check the wategate actuator to not be stuck ? eventually connect a pump to the valve and see if it moves when you pump it to make sure that the diaphragm is not leaking
 
I await correction but when it happened to me, wastegate actuator problem, the engine only ran properly again, when the engine was stopped and restarted. So if the intermittent fault happens and then all runs right again a moment later, without a stop-start at the key, I don't think it can be an over-fuelling then limp mode situation.
Wot u think @sierrafery?
 
The only update I have so far is that I've checked the actuator isn't sticking by pumping air into the inlet and it moves smoothly with no sticking at all. I had a spare vacuum hose so fitted that too.

I have a new (not cheap) fuel pump which I bought some time ago as the one I fitted 12months ago was only cheap as I was strapped for cash at the time. I intend to fit this at the weekend with a new filter. I don't know if this will make any difference but it's a job I've been meaning to do for a while.

Do you have any idea what pressures I am looking for from the wastegate on Hawkeye when I take her for a test run at the weekend?
 
I am suffering from this problem myself ...no codes and I have to turn the key off and on to resolve it or stick it in second and rev hard ......no codes either but I am waiting for my foxwell 520 to arrive.
 
Ok an update.

So, I have fitted a new fuel pump (VDO) and fuel filter and all seems well. I've done a 40 mile trip with no stutters or farts and smooth power delivery. All the figures you gave me Sierrafery all seem good apart from the Acc supply. I have a reading of 4.2v where your document states it should be between 4.9v and 5.1v. Is this something I should address?
 
You must log in or register to reply here.

Similar threads

K
Disco 2 ACE Fault
Replies
7
Views
651
kingy08
K
C
More Amigo Fun
2
Replies
20
Views
1K
Charlie Chester
C
R
Freelander 2 (LR2) Intermittent engine fault
Replies
8
Views
1K
RedMike60
R
Ashs1
D2 v8
Replies
11
Views
1K
sierrafery
sierrafery
M
Classic Range Rover Suffix D Starting Issues - Advice required please
Replies
6
Views
791
Datatek
Datatek
Back
Top