I think my 90 is up at the front!

SpaceDawg · Jun 4, 2016

Hello,

Just wondered if anyone can measure from the ground to the bottom of the wheel arch on there 90 for me. Mine seems to be sitting a little high on the front and its bugging me, I'll put a photo up later.

I have 235 x 85 on mine so the measurements can only be from the same size tyres.

Also I did replace the rear springs with OEM standard hight and load, so it might be someone whacked hd one on the front at some time.

rupert092 · Jun 4, 2016

Mine is 34 inches from ground to bottom of wheel arch, sitting on 245/75/16 tyres.

lynall · Jun 5, 2016

Why not measure axle centre to bottom of arch then you can ignore what tyres are fitted?

SpaceDawg · Jun 7, 2016

Good idea, its 50cm from the middle of the axel to the bottom of the wheel arch.

Turboman · Jun 7, 2016

SpaceDawg said:
Hello,

Just wondered if anyone can measure from the ground to the bottom of the wheel arch on there 90 for me. Mine seems to be sitting a little high on the front and its bugging me, I'll put a photo up later.

I have 235 x 85 on mine so the measurements can only be from the same size tyres.

Also I did replace the rear springs with OEM standard hight and load, so it might be someone whacked hd one on the front at some time.

In the genuine manual there are distances from bump stop to axle all round. The idea is that when they go too low, you get new springs. Might be helpful to you too.

Turboman · Jun 7, 2016

Just looked it up, bump stop to pad on axle should be in excess of 2.8 inches all round, and reasonably similar.

I think my 90 is up at the front!

SpaceDawg

Active Member

rupert092

Member

lynall

Well-Known Member

SpaceDawg

Active Member

Turboman

Mab An Gov

Turboman

Mab An Gov

Similar threads