How to stop the crankshaft pulley spinning?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
dizzytim said:
Shorting the starter will make the motor spin but you need to power the trigger wire ( spade connecter ) aswell to engage the starter first, as it's a pre engage starter
Click to expand...

So if i extend the cable from the spade connector to the + on the battery and then short the starter it will turn the crank?
 
dizzy where is this spade connector? ive just been out and there are 2 spade connectors next to each other, those are the 2 that i am shorting together to get it to spin but where do i need to run a 12v feed to on the starter?
 
If you put power to the spade connector ( only 1 on my starter ) it will energise starter and engage and turn starter, can't understand wy it's not turning engine over/ front pulley not turning ?
Thought you was shorting across the nuts to put power to the motor, when solenoid is triggered it engages the starter gear into flywheel starter ring and also connects the main power to the motor
 
If the nuts that tight I would of thought the starter probably wouldn't undo it.
One small point. Are you sure the starter is going to turn the right way to undo the nut and not tighten it up?
 
I got it undone, i found the small spade connector that you were talking about dizzytim thanks a lot, it is tucked to the side of the nuts..

it went straight away with a quick turn over by that, it was a snapped timing belt, I've changed the belt and it had only bend 5 pushrods, I've changed all 8 and couldn't get off the awkward crank cog that has the teeth on it, but there is no oil coming from the seal and the cog itself looks fine..

I just need to double check the timing for the camshaft pulley is correct so ill be searching around for info on that tonight, on my camshaft pulley i have a small dot on the pulley itself, no other markings.
 
Camshaft dot lines up with a casting on the cover at about 20 to the hour if I remember, there is a good guide if you google it:)
 
You must log in or register to reply here.

Similar threads

mad85
Disco 2 Replacing TD5 Crankshaft pulley
Replies
5
Views
270
mad85
mad85
R
Series 3 Crankshaft Pulley suddenly seized?
Replies
11
Views
888
steve2286w
steve2286w
Padda.116
300tdi auto disco 1 BURNING RUBBER SMELL
Replies
4
Views
290
patrickmoran
P
1
Broken Timing Belt
5 6 7
Replies
126
Views
5K
109Santana
1
MrGorsky
P38A Front Crankshaft Oil Seal Speedi Sleeve
Replies
6
Views
623
Ratae
R
Back
Top