How Many Greasing points on the P38?

AP90 · Jul 27, 2014

Hi Keith

Great thanks for the tips of course your sealing comment makes complete sense, I should have realised that. When you say you had to grind the sides of the gun, I can't visualise the procedure, is it to make the actual head fit deeper in the UJ?

Thanks again

Ash

ovalandrover · Jul 27, 2014

AP90 said:
Hi Keith

Great thanks for the tips of course your sealing comment makes complete sense, I should have realised that. When you say you had to grind the sides of the gun, I can't visualise the procedure, is it to make the actual head fit deeper in the UJ?

Thanks again

Ash

1 way to do it is to fit longer grease nipples
another way is to loosen off the grease nipples until the gun fits but tighten then up after the grease is in

Datatek · Jul 27, 2014

AP90 said:
Hi Keith

Great thanks for the tips of course your sealing comment makes complete sense, I should have realised that. When you say you had to grind the sides of the gun, I can't visualise the procedure, is it to make the actual head fit deeper in the UJ?

Thanks again

Ash

Yep, just 2 flats on the side of the nozzle. there was no way my Wanner gun would go in far enough otherwise. You can get long nipples but it's fag taking out the normal nipples, fitting the long ones to grease then putting the originals back after.

How Many Greasing points on the P38?

AP90

Active Member

ovalandrover

Well-Known Member

Datatek

Well-Known Member

Similar threads