High Pressure Header Tank - Oil In coolant

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

m4rk

New Member
Posts
8
Can anyone help???

I have a 1998 Discovery(1) 300 TDI.

The other day I had steam coming out from under the bonnet and found that the header tank had breached at the seal round the edge. I don't know much about this stuff but am prepared to try anything. I have bought another tank and fitted it, refilled the cooling system (from themostat cap) and ran the engine for 5 mins with the cap off the header tank to clear any air bubbles etc. If I tighten the header cap a big pressure builds up very quickly.

With the header cap off and the engine running the coolant just swells out of the header tank every 10 seconds or so and little bubbles keep coming. I noticed wisps of smoke coming out of the header tank which are quite fumey and I also noticed a slight grey oil in the coolant when I uncrewed the cap on the top of the thermostat again to clear air blocks.

I've spoken to a Landrover dealer who said it might be the head gasket 'or worse' which I'm assuming is a cracked head. Or it might be the oil cooler?

If anyone has any guidance on this it would be much appreciated.

Thanks


Mark
 
m4rk said:
thanks robint. Definately no chance of being the oil cooler? (ever hopeful)
Click to expand...

If your oil cooler is leaking oil into the coolant, you will get a LOT of black oil in the coolant - it's unlikely to overpressure like yours seems to be, not in the very short term anyway - and your oil level will be dropping over a period of time.

Yours sounds like head gasket to me.
 
that happened to me last week i thought i could just renew the coolant resivour but had the same symptoms as yours and im amfraid to say its the head gasket, mine went between number 2 and 3 cylinder, i got my head skimmed and pressure tested for £50.
it is a fairly straight foward job to do.
sorry its not the answer you were hoping for
 
Defo the head gasket, you can't just change the gasket tho, you will need head skimming and pressure testing or new/recon head fitted, mine went between 2 and 3 twice. Had head skimmed 1st time then recon head 2nd time
 
OK - Got head off. The gasket is a 3 hole one. If I don't skim can I just replace with the same?

I don't know what I was expecting but couldn't see any breaches between coolant and piston ducts. The gasket was in one piece. I assume the breach is much smaller?

I know the best thing to do is get the head skimmed and I am trying to find a place to do this. Has anyone done a head gasket and just cleaned it up? If so what's the best method for this.?
 
just had excactly the same was head gasket gone between 2 n 3 ports for the second time, i was told that it went the second time because i never bled the water system ?? make sure you do that!!!!
 
Thanks Kernow oli and all.

The haynes manual refers to a coolant plug on the left hand side of the engine block. I can't find this anywhere. Does anyone have any pointers?
 
You must log in or register to reply here.

Similar threads

C
Coolant Header Tank
Replies
4
Views
606
kernowsvenski
kernowsvenski
S
Coolant leak overflow
2
Replies
25
Views
1K
sierrafery
sierrafery
G
300Tdi coolant issue
Replies
2
Views
577
GilesHarrison
G
Bustrucket
Disco 2 Td5 Overheating
Replies
3
Views
839
johnlad
johnlad
M
Pressure in coolant
Replies
2
Views
676
biketeacherdave
biketeacherdave
Back
Top