Help with level sensors setting

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
To store heights turn ignition on and go untill "SLABS - Utility - SLS calibration" then if the bubbles are at the middle simply store heights dont play with raise/lower commands, if it asks to "write settings" do that too... once stored turn ignition off, wait 60 seconds then unplug nanocom otherwise it might miss the settings
 
Also, just to clarify, the readings you see for the heights do not equate to an actual measurement - e.g. xxx mm. This does sometimes confuse people.
Griff
 
sierrafery
Got the nanocom and your advice was perfect. worked a treat, all fine now.
Just another Question does any body know the part numbers for the height sensor bolts?
Thanks again for all the great help.
 
Back
Top