I tried looking for them but couldn't find any specific thread on this forum with instructions on how to calibrate? I saw the YT videos with the block method, I'm wondering how does the measuring stick method work?
P38A Height Sensor replacement
- Thread starter J L Carr
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Oh, gotcha, thanks! So I start by putting the suspension as high as it goes with the Nanocom, right? Without the blocks, if I deflate the airbags, it won't rest on the blocks to get to the correct height, is it going to drop down to access level, or how does it work exactly?
Datatek
Well-Known Member
- Posts
- 45,063
- Location
- Near Poitiers SW France
You adjust each corner to the mark on the measuring stick so it aligns with the edge of the wheel arch starting at wade height and working down to each of the other 3 levels. With blocks, you have to crawl under the car which IMO could be dangerous if you do not know what you are doing.
- Posts
- 19,317
- Location
- Buckinghamshire, UK. ('95 DT)
You can do almost anything with a Nanocom, so yes.
UnitLandy
Member
- Posts
- 63
- Location
- Whittonstall
Datatek
Well-Known Member
- Posts
- 45,063
- Location
- Near Poitiers SW France
The connectors can give trouble and wiring failure is a possibility.
