Height Sensor Replacement help and advice required.

Looking to change o/s front and rear height sensors on 2000 rangie, can anyone direct me to a video on how to replace. I also have EASunlock software but not too sure how to use it, again any advice would be welcome. Thanks!

Use the EAS software to read the current height settings and write them down as a point of reference. Ignition off and tailgate open to freeze the suspension. Jack the car for access not forgetting axle stands for security, remove defective sensor and replace. Remove axle stands and the jack, start the engine, close the tailgate. wait for the suspension to come up and then measure the heights at each corner and adjust as necessary at each height setting with the EAS software. Do a search here for suspension heights or look at RAVE. Irish Rover has posted the height settings many times.

Scroll down this link for the video on the EAS Software.

As Datatek has stated read the EAS setting and write them down also measure the wheel arch to ground distance, as each height sensor will be different. Then fit the new sensors, then re-adjust the setting to obtain the correct wheel arch height distance.


PS......Greavsie, if you stated your location in your profile you might find someone local to help.....

Thanks for the advice. I'm based in Peterborough, I'll update mi profile.

Greavsie said:

Thanks for the advice. I'm based in Peterborough, I'll update mi profile.

Click to expand...

greavsie,got my pm yet.