P38A Heater Feed hose, I didn't know it existed

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
E

EntropyUK

Well-Known Member
Posts
467
Location
Hemel Hempsted
My Diesel blew a hose on Thursday night and needed recovering home. Lots of steam and a squeaky bum as I did not know that there was a hose at the back of the engine so every worst case scenario went through my head. Whilst it cooled down so did I and found the little U shaped hose had blown.

Ordered replacement off Ebay as I was put off the Britpart sold by Island. Now regretting it as have been told it was posted on Thursday 1st class but still not here. Phoned local motor factor and Dingocroft with no luck so looks like I will be stuck tomorrow as no second car at the moment. Also not happy as my boss is an utter jerk and is moaning like hell about me working from home 2 days running.
 
It was tight but a screwdriver acting as a pick worked getting it off. Had to remove inlet manifold to get at the clips. the one nearest the bulkhead was twisted so one of the tangs was also up against the bulkhead. I have the tool to compress these but a set of angled long nose pliers did the job.
 
EntropyUK said:
It was tight but a screwdriver acting as a pick worked getting it off. Had to remove inlet manifold to get at the clips. the one nearest the bulkhead was twisted so one of the tangs was also up against the bulkhead. I have the tool to compress these but a set of angled long nose pliers did the job.
Click to expand...

Is there a pipe the other side too?
 
Yes metal heater matrix other side. They can burst but not very often/likely. Mark has a thread 'you wouldn't believe it' where his rad blew in his face for no apparent reason. Very lucky man. The thread goes go off on tangents mind ;)
 
If that one has rotted through check your front one as well. Turner Engineering do one inc postage circa £11. I have had a rear pipe made up for me, luckily my Heath Robinson field repair has held up so not changed them yet. Will do shortly as another trip to Rochechouarte coming up, that 1500 mile round trip seems to tax any P38 weak bits that for sure :rolleyes:
 
When mine leaked it was corrosion on the metal cross pipe end behind the engine. Knackered the hose somewhat. Fitted a new metal pipe and a new hose. However the new aftermarket hose (who would be stupid enough to pay for a Land rover one?) had a smaller O/D than the replaced one so the spring clips would not hold it. I just applied a little Hylomar inside hose and on fittings and used stainless jubilee clips. That was three years ago and still sound.
 
You must log in or register to reply here.

Similar threads

M
P38A Leak
Replies
2
Views
710
nigelbb
N
Rusty Bucket
Modify front brake hose bracket
Replies
3
Views
399
v8250
v8250
B
Help!! Severe lack of power FL2 TD4
Replies
5
Views
790
WhiskyLassie
WhiskyLassie
Charliestbc
Freelander 2 power steering hose
Replies
9
Views
3K
I like chips
I
Gertrudethedefender
Engine to Radiator coolant hose replacement
Replies
17
Views
2K
Anaconda
A
Back
Top