Half shaft nut retaining clips

cornish rattler · Nov 28, 2023

Hi guys
Whilst the landy is in the garage i thought i would cure a front hub oil leak ( gasket leaking ) and to remove the outer hub you need to remove the half shaft castle nut ( held in by a split pin ) and it got me thinking, why do all series landy's not have the retaining clips anymore as removing and fitting one is a lot more easier than messing with a split pin

Wildefalcon · Nov 28, 2023

Only the post rationalisation series 2/3 didn't have the castle nut & pin.

It's cheap, easy to work with, so why change?

Palagius · Nov 28, 2023

If stuck you can always find something to do the same job as a splitpin

tottot · Nov 28, 2023

Vice grip is your friend for split pin removal.

cornish rattler · Nov 28, 2023

Yeah i've done loads of the half shafts with split pins but when doing them i always remember my dads 1964 S2a having the clips and they was always easier

tottot · Nov 28, 2023

My 63 2a has split pins. Could it be your dad found something better?

cornish rattler · Nov 28, 2023

tottot said:
My 63 2a has split pins. Could it be your dad found something better?

No i think they was in there from new

cornish rattler · Nov 28, 2023

It was a wierd thing obviously the pin part of the clip went in the hole then the clip part of the clip gripped its self round the nipple on the end of the half shaft so you had one on all 4 half shafts

tottot · Nov 29, 2023

Sounds much like lynch pins, larger versions are in common use with agriculture equipment. Small versions are available, some that are a one piece of folded wire.

Half shaft nut retaining clips

cornish rattler

Well-Known Member

Wildefalcon

Well-Known Member

Palagius

Well-Known Member

tottot

Well-Known Member

cornish rattler

Well-Known Member

tottot

Well-Known Member

cornish rattler

Well-Known Member

cornish rattler

Well-Known Member

tottot

Well-Known Member

Similar threads