Got crank no start

Wilby4220 · Sunday at 22:48

So last night it crank but no start would have to push throttle down for it to run up then would run for 10mins then go into limp mode and engine would just stall itself. Had happen 3 times today and when got back going it sit at idle fine only when you go down the road it gives in
Ecu plug is clean
Fuel filter was replaced 4 months ago
Oil doesn’t smell of fuel Ore gone up the stick
So all I can think of it being is crank shaft sensor anyone help me with anythink else to look for ore clean/replace for it to sort it’s self thank you
Cal

lynall · Monday at 07:39

Welcome to LZ.

Trivia question, did you know they made several versions of the Discovery running from 1989 to current day? If you would be kind enough to avail us that information, then just maybe someone can help you.

saxavordian · Monday at 07:46

Age of vehicle
Diesel engine model
Petrol engine model
Diagnostic information

Stanleysteamer · Monday at 14:47

If it is a Disco 2 TD5, look at the wastegate actuator, make sure it is solidly fixed then count the turns down the thread, there should be 13 showing.

Saxa...said "get a diagnostic"

Wilby4220 · Monday at 15:25

saxavordian said:
Age of vehicle
Diesel engine model
Petrol engine model
Diagnostic information

2.5 td5 engine I’ve had it scanned and nothing is coming up on it why iam leaning to crank shaft sensor

Wilby4220 · Monday at 15:31

I’ll have a look and see when iam home I’ve scanned it myself with a snap on computer and it’s not coming up with anything why iam thinking the crank shaft sensor I washed it yesterday and started the issue after that

Stanleysteamer said:
If it is a Disco 2 TD5, look at the wastegate actuator, make sure it is solidly fixed then count the turns down the thread, there should be 13 showing.

Saxa...said "get a diagnostic

Anaconda · Monday at 20:55

Faulty reading by the crank sensor, affected by starter motor in my case, puts on the EML and gives you a fault code.

Wilby4220 · Monday at 22:57

Anaconda said:
Faulty reading by the crank sensor, affected by starter motor in my case, puts on the EML and gives you a fault code.

Yh right well tbf I’ve had no fault codes took my red plug of ecu and found oil and tbh good chance water got into the crank sensor when I’ve washed it Saturday night

Got crank no start

Wilby4220

New Member

lynall

Well-Known Member

saxavordian

Well-Known Member

Stanleysteamer

Well-Known Member

Wilby4220

New Member

Wilby4220

New Member

Anaconda

Well-Known Member

Wilby4220

New Member

Similar threads