front brakes

whitstella · Sep 13, 2014

Hi

Just been building my front brakes on my 88. I think everything is built right but adjusting the brakes I can spin the wheel forward easily but when I try moving backwards it goes tight. And ideas fokes.

Cheers steve

Blackburn · Sep 13, 2014

The rear shoe is a trailing shoe and will catch , if it is too tight chamfer the top edge of the rear shoe lining with a file.
When I fitted Mintex shoes the liner was bonded higher up than it should have been and I had to file a significant amount off so that I could reverse.

oxides · Sep 13, 2014

.....and double check the springs are on right!

tottot · Sep 13, 2014

Make sure pistons are free.

whitstella · Sep 14, 2014

Hi

It's a new cylinder so pistols should be ok. Can you describe where the springs go!?? The bottom spring I have got going from brake shoe to brake shoe, the top spring goes from the post from 1 shoe to the back plate post so as I look at my brakes, the shoe which is nearest the rear only has 1 spring connecting to it and it's the bottom spring. I can easily pull the shoe from the piston. Does all this sound correct???

Cheers steve

nickjaxe · Sep 14, 2014

As stated...file a chamfer on the back edge of the shoes...common problem.

front brakes

whitstella

Active Member

Blackburn

Well-Known Member

oxides

Well-Known Member

tottot

Well-Known Member

whitstella

Active Member

nickjaxe

Well-Known Member

Similar threads