Freelander 1 fault code P0130.
- Thread starter MathiasL
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Looks like this is for the 2005 1.8, it should not be hugely hard I believe it is located on the exhaust manifold headers and the issue will be that it is rusted in. Good luck! I am sure someone will be able to provide more accurate details with pictures.
Yes, the 1.8 petrol in the 2005 model Freelander. Apparently, it has two of these (one pre- and one post-cat) and this seems to be the easier one
Thanks!
Ah there you are thenYes, the 1.8 petrol in the 2005 model Freelander. Apparently, it has two of these (one pre- and one post-cat) and this seems to be the easier one
Thanks!
I still think Rust is going to be your main gripe, if you have a blowtorch, minding the wires, put it to use, great for rusty bolts and nuts
I think this may help: https://www.landyzone.co.uk/land-rover/lambda-sensor-plug-location.281149/ sounds like you need to access it from the centre console.
J_D
Well-Known Member
- Posts
- 639
- Location
- Worcestershire
A decent o2 sensor socket is a must. It has a cut out for the cable. Maybe a short breaker bar.
I think my faulty sensor is the one located near the engine, fortunately!
In that case it should be similar to my 1.8, I will be working on the headers this weekend, I can grab some pics for you if you like?
It would be appreciated! If I get my sorted before that, I'll be sure to upload some pics or a video of how I managed.
andyfreelandy
Well-Known Member
- Posts
- 5,560
- Location
- Devon
Special O2 sensor socket won't fit in gap. O2 sensor is on the engine side of the exhaust manifold.
if it is duff, best plan is to cut plug off it and thread a ring spanner on that fits tightly to prevent rounding. Then a sharp blow with a hammer to unscrew it. Soak with penetrating oil for a day or so and then carry out removal with a warm manifold. Not too hot or you burn your pinkies !
if it is duff, best plan is to cut plug off it and thread a ring spanner on that fits tightly to prevent rounding. Then a sharp blow with a hammer to unscrew it. Soak with penetrating oil for a day or so and then carry out removal with a warm manifold. Not too hot or you burn your pinkies !
Literally just got the pictures!So, this is the O2 sensor nr 2, the one after the cat. Where is no 1?
Pictures would be nice
View attachment 326551
In-between all the headers on the exhaust
Kinda hard to see but it is the cable in there (I am looking from on top with no heatsheild) keeping in mind this is a pre2001 FL1
Similar threads
