Flywheel run out 200tdi

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
payydg

payydg

Well-Known Member
Posts
3,929
Location
Aberdeenshire
Almost finished the engine rebuild after flooding the engine during a river crossing.

Measured the run out of the fly wheel and its 0.15mm (max is meant to be 0.07mm).

Is this a major problem? It's a 200tdi so I was just going to spit on it and stick it back on?
 
lynall said:
Are you sure the crank did not move a back/forth a knatts cock as you rotated it? ie the amount of play in the crank thrust bearing.
Click to expand...
That's a good point - maybe although the part of the fly wheel that has more run out is the same every rotation if you get me and across a largish fraction of the wheel which makes me think its not the crank play

I'll double check tho

If it is the wheel, need a new one/get it skimmed?
 
payydg said:
That's a good point - maybe although the part of the fly wheel that has more run out is the same every rotation if you get me and across a largish fraction of the wheel which makes me think its not the crank play

I'll double check tho

If it is the wheel, need a new one/get it skimmed?
Click to expand...
Think only the other week someone on here was selling a freshly skimmed 200 flywheel.
As it is an arse job to get box out once the car is together I would be inclined to sort it out while it is easy to get at.
 
You must log in or register to reply here.

Similar threads

Birdbrain
200tdi clutch slip
Replies
5
Views
1K
payydg
payydg
P
Voltage reading in ground cable(s)
Replies
2
Views
442
patrickr90
P
Lej
Fast idle speed (tick-over) + other queries!
Replies
3
Views
1K
lynall
L
S
Td5 starts but will not run without holding key
Replies
8
Views
1K
Shane3427
S
W
200 Tdi crank damper mount shot - what to do
2
Replies
38
Views
4K
wileycat
W
Back
Top