Engine not starting FL2

HI All,

Can anyone shed some light on the following problem. FL2 fuel filter changed recommended every 12 months filter was primed but may not enough. Filter and lines have been bleed using hand pump. injectors hoses have been bleed also. battery hold full charge currently at 14.7 volts. fuses checked. Immobiliser checked. unfortunately the engine is cranking but will not fire up.... all working like clockwork before. recent works carried out ( service, hence fuel filter and turbo actuator replaced due to loss of power) has anyone had the same experience. ( could it be possible crank sensor? though landy was running well before hand)

any help advice greatly appreciated

Thanks

Fuel filter is every 2 years, not yearly. Only use OE or genuine filters too. Only bleed the system using the correct hand pump, and never pre-fill the filter, as the injectors are easily clogged, as the injection ports are 5 microns across. Also never crack the fuel lines, as they're single use, and should be replaced once the nuts have been disturbed.

Thanks Nodge ,

any thoughts to why she wany fire up i am thinking electrical

Genuine filter Brit Part supplied by Craddocks. Correct bleed kit and pipes supplied ( all air out of lines i have bleed a number of times 330ml of fuel each time to make sure) could it be immobiliser or possibly fuel pump. fuse all good even changed 60 amp down the side of the engine compartment fuse box.

Do you have any codes?
Daft question - got plenty of fuel? (over half a tank, to rule out the pump in the tank)