Electricmarbles
Member
- Posts
- 37
a
Last edited:
Electrician needed
- Thread starter Electricmarbles
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
storm99
Spreading Joy & Harmony
- Posts
- 21,065
- Location
- Brexited. Living on an island.
The towel might not be earthed.
TheKeymeister
Active Member
- Posts
- 772
- Location
- Lincolnshire
"only" 90%? That's not bad!
Post up what's wrong with it and we might be able to help you sort it!
Post up what's wrong with it and we might be able to help you sort it!
- Posts
- 7,332
- Location
- Under my landy
Series Electrics are fairly straight forward, i'm sure with a big of guidance we can help out with your problems...
Electricmarbles
Member
- Posts
- 37
a
Last edited:
First step is check that you have connected the lamp units in to the main loom correctly and got good earths at each lamp . You should have both working on one side if one works as they are common feed from the indicator stalk . Have you got a hazard switch, if yes what happens when you operate it ?
Electricmarbles
Member
- Posts
- 37
a
Last edited:
disconnect wires at indicator lamps , connect 1 lamp at time , this will track it down to one lamp. When you find which lamp has short as a quick try reverse connectors to what they were before. I have come across incorrectly wired lamps eg the supposed supply wire going to the earth on the lamp which has a earthing strip under a fixing screw which shorts to earth . You didnt answer if you are in Buckingham , if you would rather not thats no problem
Electricmarbles
Member
- Posts
- 37
a
Last edited:
Electricmarbles
Member
- Posts
- 37
a
Last edited:
kgopa
Member
- Posts
- 57
- Location
- South Africa
Get some 7 core trailer wire, pull it through to the back, and a piece to the front, join the front and back park lights, and flickers and join to the existing wiring behind the dash. You can install some relays for headlights if you like. At the back you will have two wires extra for reverse light or interior light etc.
Last edited:
Its a bit difficult without knowing what your 20 amp relay on flashers is wrired as but on the face of it that could be a problem . another thing is box 4 (28) a fuse if not you have got no fuse supply to your spot lamps only the switched feeed for the relays for the lamp (less than 2 amps is fused) Its a nicely drawn diagram tho !
Electricmarbles
Member
- Posts
- 37
a
Last edited:
Electricmarbles
Member
- Posts
- 37
a
Last edited:
Ain't solved my problem yet...
I replaced the front indicators and side lamps - worked fine until night time. Turned out when I put on the dash panel lights the indicators stop working.
1984 S3 - wiring been messed about with a fair bit (only had it a month) - any ideas for when I take off the dash again...!?
MC
I replaced the front indicators and side lamps - worked fine until night time. Turned out when I put on the dash panel lights the indicators stop working.
1984 S3 - wiring been messed about with a fair bit (only had it a month) - any ideas for when I take off the dash again...!?
MC
nrgserv
Well-Known Member
- Posts
- 4,208
- Location
- shipley, west yorks.
is this a seperate issue to the op's?
if so, where are you in north yorks?
