P38A EAS pipelines

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
oakey

oakey

Well-Known Member
Full Member
Posts
2,101
Location
Mull of Kintyre
Hiya 95, 4.6 auto 186k
Can anyone recommend a good way of bending the eas pipes?
I am having to change the front left bag pipe and is difficult to get it to go straight in collets
Ta much
 
They're plastic aren't they? How far along do you need the bend?
My first try would be to plug the end (to keep dry) then dunk into some hot water straight from the kettle to soften
 
Not sure if I have any thick enough but could try just putting finger over end to let air pressure keep it open?
 
I replumbed the whole of mine straight off a coil of industrial type tubing for not much money. Put a pressure guage in line for the receiver. Never even considered the need for bending as such. Had to be creative with ties. There are connectors, bends and Tees available if you really want to plumb it tidily.
 
I would use my tube bender i use for brake and fuel lines. Heat it up area of bend til pliable and use bender remove when cool..
 
Pipes dont really need bent just the original ones are
Thanks for all your replies
I dont have a bender so will probably just leave them straight
 
As an addition, where do the wires from the sensors go?
Direct to ECU under passenger seat?
I think I need to clean the contacts.
 
oakey said:
As an addition, where do the wires from the sensors go?
Direct to ECU under passenger seat?
I think I need to clean the contacts.
Click to expand...
The usual place for EAS contact problems is the large white connector at the base of the nearside a post behind the plastic panel. Removing the connector and soldering the wires, protecting with heat shrink cures a multitude of problems.
 
Thanks datatek, I thought those wires were for the switch and the electronic thingy beside the valve block. I think I will be doing that as soon as rain stops
 
You must log in or register to reply here.

Similar threads

Montyjohn
P38A A couple of queries about rebuild EAS valve block
Replies
9
Views
685
Grrrrrr
Grrrrrr
IandiscoV8
P38A EAS Fault finding threads or files.
2 3
Replies
55
Views
5K
Mark Piercy
Mark Piercy
300bhp/ton
P38A Odd EAS behaviour - sinking front
Replies
19
Views
1K
Mark Piercy
Mark Piercy
rangie1998
P38A EAS some more questions!
Replies
16
Views
2K
rangie1998
rangie1998
W
P38 EAS Down on One Corner
Replies
9
Views
2K
pwood999
pwood999
Back
Top