P38A EAS HELP

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
H

hughandjen

Active Member
Posts
95
Location
Kendal
Hi guys
HELP
I have just renewed the EAS block o rings.
All seem to go well. Air pipes all located. No apparent air leaks but
After 8-9 mins the rear end goes up to FULL Wade height but the front just sits there on its bump stops.
The switch in the cab flashes as if it’s trying to pressurise but still there. left it running a further 10 mins but nothing.
Any advice before I pull it apart again.
Thanks
 
just an update. So the car is stuck with the rear end fully up and the front on its bump stops. If i instruct it to go to full height, the compressor kicks in but the front doesnt move. if i instruct it to go to normal drive height or access height the compressor stops but the rear stays jacked up in the air.
 
ok just checked the wires leading from the valve covers against an EAS block schematic and all the top ones are leading to the correct position on the plug. Ill have to take the unit out again to check the lower valvaes which are for rear righjt and front left springs
 
Grrrrrr said:
Have you got the EAS Unlock suite and cable? Are the valves opening? No leak at the front?
Click to expand...
No I havent got the unlock suite. Does it plug into the OBD2 port? if so mine has no power to the OBD2. No apparent leaks on the front.
I dont get any EAS warning lights on the dash at all though
 
hughandjen said:
No I havent got the unlock suite. Does it plug into the OBD2 port? if so mine has no power to the OBD2. No apparent leaks on the front.
I dont get any EAS warning lights on the dash at all though
Click to expand...
From memory pins 4&5 are grounds and pin 16 is the positive on the port think its a brown wire check the block connectors at the base of the A post,behind the kick panels both sides.they usually corrode and are best cut out and the wires soldered and heatshrunk.
 
tomcat59alan said:
From memory pins 4&5 are grounds and pin 16 is the positive on the port think its a brown wire check the block connectors at the base of the A post,behind the kick panels both sides.they usually corrode and are best cut out and the wires soldered and heatshrunk.
Click to expand...
Thanks I’ll check that out
 
hughandjen said:
No I havent got the unlock suite. Does it plug into the OBD2 port? if so mine has no power to the OBD2. No apparent leaks on the front.
I dont get any EAS warning lights on the dash at all though
Click to expand...

Yes. If the pollen filters have leaked it can get corroded. Some electrical contact cleaner and a toothbrush or some mouse files will clean off any green corrosion. There's a fuse for the ODB port too but I cannot remember which one. Fuse 2?
 
You must log in or register to reply here.

Similar threads

K
Is my RR Classic in EAS shutdown?
Replies
12
Views
857
kevleaper
K
Flossie
P38A Eas issues
2
Replies
22
Views
1K
Datatek
Datatek
J
P38A p38 EAS - immediate drop of pressure
Replies
11
Views
608
Mark Piercy
Mark Piercy
Henry_b
P38A EAS fault
2
Replies
34
Views
2K
Datatek
Datatek
feyniriel
P38 EAS problems
Replies
18
Views
1K
pwood999
pwood999
Back
Top