P38A does any one no how to undo the drivers side bonet cach i put battery back in and cought it it disconected it cant get bonet open thanks john
- Thread starter dodge man
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I guess you will soon be eligible for a frequent posters card on here : o) They way i did it was to initially remove the grille, you may have to snap the plastic tabs at the top retaining screws. then you will have restricted access to the underside of left and right hand locks - you need to push left and pull right, if i remember correctly (cd be the other way round) to open the retaining "crescent, and allow the bonnet catch to release on each side.
I did read a post once that said you could magically lie below the car and get a long screwdriver and do all this from underneath the car, but I couldn't see any way in myself.
Good luck - it's not so hard, but needs a bit of patience, and a decent light so that you can see what you're doing
I did read a post once that said you could magically lie below the car and get a long screwdriver and do all this from underneath the car, but I couldn't see any way in myself.
Good luck - it's not so hard, but needs a bit of patience, and a decent light so that you can see what you're doing
brianp38dse
Well-Known Member
- Posts
- 20,011
- Location
- heathrow
i have just posted how to do it on your other thread
thanks it one thing after another the good ting is the left side still works then iv got to get it to run again
hi i cant fined it thanks john
brianp38dse
Well-Known Member
- Posts
- 20,011
- Location
- heathrow
I had a problem with my bonnet catch ended up with a flat crowbar to tease up it up enough to get a ratchet ring spanner on the bolts and undo the latch its a right ball ache but can be done.
There you go.
There you go.
hi got it undun if one of the catches works open it leaver up bonnet up put block under it you can undo the screws on grill with pliers remove grill the post were bonnet catch is bolted on to there is a hole in it but hard work trying to undo catch drill a big hole ferther up it makes it a lot ezeyer to un do hpe this helps any one els that has this prob
Similar threads
