Discovery Sill Replacement
- Thread starter Paul D
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ashleywood.ash
Active Member
- Posts
- 558
- Location
- sheffield uk
Where you located
skunk98
Member
- Posts
- 93
- Location
- Gwent,South Wales
Try a local steel stock supplier if possible. You should only need 100x60x3 for most upgrades.
ashleywood.ash
Active Member
- Posts
- 558
- Location
- sheffield uk
Don't know down there,
Find an industrial site with a few engineering firms on and ask them, that's how I found a couple up my end
Find an industrial site with a few engineering firms on and ask them, that's how I found a couple up my end
another forum
Active Member
- Posts
- 207
- Location
- Bromsgrove
I got mine from metal supermarket 100x60x3.2mm.had change out of £40
d69
New Member
- Posts
- 7
- Location
- Aberdeenshire, Scotland
Another revival of this magic thread, I've just started to replace my cills yesterday but I am really unsure on what to cut away and what to leave. The main problem I am having is that there are 2 brackets, at the front end of the passenger side, and probably the same at the other side 
Should I just cut through them and weld them back on to the new cill or do I leave them as is and make the cills shorter by about 75mm??????
I can't seem to get the old cill out from under the floor either but that I can work around.
Cheers
Should I just cut through them and weld them back on to the new cill or do I leave them as is and make the cills shorter by about 75mm??????
I can't seem to get the old cill out from under the floor either but that I can work around.
Cheers
