Discovery 300tdi starting problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
J

Johnny8718

New Member
Posts
13
Hi All.

When I come to my 1996 300 in a morning, I have loads of power in the battery.

Glow plugs light and go out.

I crank the car over, but it won't catch. As soon as I release the key, it stops - refusing to fire.

I have tried holding it on the key with no success. The only way to start from cold is to hold the throttle down and then it does start.

This is not a good idea when cold!

Any ideas? It reminds of the ballast resistor fault on old Cortinas - I am assuming that the Disco does not have one!

Thanks in anticipation, John.
 
You have lost me??

I searched the site and couldn't find the answer???

Does anyone have/has had a similar issue?

Thanks, John.
 
Last edited:
Johnny8718 said:
You have lost me??

I searched the site and couldn't find the answer???

Does anyone have/has had a similar issue?

Thanks, John.
Click to expand...

Una vita - vitate (It is supposed to say One Life-live It)

It could either be Italian, Latin, or a spelling error.
Italian: "vitate" is no such verb, probably means "vivete"
Latin: "vitate" means "avoid," but the person did not mean that.
Thread: Discovery 300tdi starting problem Reply to Thread
 
Hi I'm new to this site and was hoping someone could help I have a discovery t reg not td5 my problem is I can bump start the truck and then it will run and start fine for a few days then all of a sudden I will go to start it and it won't start it will just turn over and over but won't fire up if I put a rope on an give it a bump it will start and run an will then last sometime 2 days other times a week starting fine hot or cold then all ov a sudden It won't start again for no reason I've left it over night and tryed again but it will not start unless it bumped any idea please sorry if I'm in the wrong section on here I'm not sure where to post
 
In my humble opinion is is loosing pressure in the fuel system and just by revving it with the starter it does not built up enough in order to start.
Giving a pull start revs it continuously and pressure is there,it ignites then.
Try to check all connections in the fuel system, renew copper washers, bleed for air and hope it will help !
cheers,
Tibby
 
You must log in or register to reply here.

Similar threads

S
FL2 starting problems
Replies
11
Views
955
Scaz93
S
loonyspoony
Disco 1 300TDI No Start
2
Replies
29
Views
1K
Stanleysteamer
Stanleysteamer
freelander03
Freelander 1 Cold starting issues - What I've done so far
Replies
9
Views
359
freelander03
freelander03
L
Intermittent starting issue.
Replies
4
Views
409
Anaconda
A
F
P38A Starting issues.
Replies
7
Views
679
kermit_rr
kermit_rr
Back
Top