Dieselmec 42
Member
- Posts
- 50
- Location
- Scotland
Hi guys and gals, finally burst 3 of my 22" rims and I've got some disco 2 wheels with 18" Tyres,just wondering if they will fit or what other options I have for wheels.
Discovery 3 wheels on an l322.will they fit
- Thread starter Dieselmec 42
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 13,560
- Location
- Sud ouest France !
Ooh good question, is it for road use or offroading?
brianp38dse
Well-Known Member
- Posts
- 20,377
- Location
- heathrow
Disco 2 or 3 wheels, disco 3 should fit provided they will clear the brakes depending on what model l322, disco 2 wheels the center hole will be to small to go over the hub flange, but only way to find out is try umm.
stuu
Well-Known Member
- Posts
- 1,980
- Location
- Aberdeenshire
02-05 Yes they do just bolt on and go, I had discovery 3 wheels on my td6 for a while.
Dieselmec 42
Member
- Posts
- 50
- Location
- Scotland
N
No just for general use
Dieselmec 42
Member
- Posts
- 50
- Location
- Scotland
No worries, mines is a 2003 td6, but I suppose your right I will just give it a try
Dieselmec 42
Member
- Posts
- 50
- Location
- Scotland
Sus,it out ,die grinder and red grease,the only difference is the wheel nuts but I had both sizes,there isn't that much you need to buff off the rim,so good bye garbage 22"stormer,rims hello factory fit wheels,I will post a picture when am done, cheers folks
brianp38dse
Well-Known Member
- Posts
- 20,377
- Location
- heathrow
The wheels use the hub part to locate and support the rim you can not grind the hub flange of and make them fit it will put the load in the wrong places and could cause problems
Datatek
Well-Known Member
- Posts
- 46,053
- Location
- Near Poitiers SW France
Not to mention the risk of being off centre.
.
Dieselmec 42
Member
- Posts
- 50
- Location
- Scotland
Don't panic,I put the wheel in my lathe and took a sklif off it and tidied the hub up with a die grinder with one of those handy flappy barrel disks that attaches to the grinder,done my measurements and they're all fine,and then went for a drive,my god what a difference in a car,the 22" wheels were on it when I got the car and other than they look good they do absolutely nothing for your comfort.
Datatek
Well-Known Member
- Posts
- 46,053
- Location
- Near Poitiers SW France
That must be one hell of a lathe to swing a wheel over the bed
Similar threads
