Evening all, got a 96 discovery 1 with abs fault keep getting a 2-12 code for front right sensor air gap, no play in the wheel bearings swive hub is tight new sensor, wiring is good, can clear the code and get half a mile before the fault is back anyone had this it’s driving me mad!
Discovery 1 abs nightmare
- Thread starter diko93
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
That doent mean it can't be play in the reluctor ring so better work on that hub, i'm not sure how the D1's hub setup is there but if the sensor and wiring are ruled out the problem can be only in the hub or eventually the ECU
discool
Well-Known Member
- Posts
- 13,609
In reality that’s all u can do, the wheel sensor system isn’t that complicated so if you have replaced or reassembled as instructed in LRs workshop manual u shouldn’t have an issue.
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
I dont know haw hard of a job it is but for a better conclusion you should swap hubs between sides to make sure it's not some intermittent wiring issue
I’ll have to root the workshop manual out and check everything, it’s the most simple abs system I’ve had to play with and the only one I’ve struggled with to this degree.
The cv must be moving somehow causing the air gap to vary, just can’t see how and don’t want to blow the parts cannon at it
I swapped sensors about and at first the fault moved with the sensor so fitted all new sensors now I’m just left with the fault on that hub
mystery
Well-Known Member
- Posts
- 1,510
- Location
- BULKINGTON
more info
Yeah I’ve had it stripped I thought that might be the issue but looks pretty good and when the driveshaft is day in it feels nice and tight might be worth chucking a new one in see if that helps
