Disco gearchange

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
The V8 man

The V8 man

Well-Known Member
Posts
1,951
Location
Redhill Surrey
just got our Sreg Safari 300tdi on the road seems to be running well except for the gearchange from 2nd to 3rd, im sure there should be a spring there to assist the change like the one in my transit, is this an easy fix ?
 
When you select neautral does the gear stick sit in the middle between 3rd and 4th? There are 2 springs and a bias plate that centralise the gearstick if a spring or the plate is faulty it will cause the gearstick not to sit in the middle and poss cause difficult gearchange.
 
more likely to be a cracked bias plate than broken bias springs. bias plate has slightly oval holes, test drive the gear change before riveting it all back together as a little adjustment may make all the difference.
 
1st and second seem ok its goin to 3rd thats a bit hit and miss and changing back from 5th to 4th ot 3rd to 2nd so maybe one spring is broken, what does the bias plate do ?
 
The V8 man said:
1st and second seem ok its goin to 3rd thats a bit hit and miss and changing back from 5th to 4th ot 3rd to 2nd so maybe one spring is broken, what does the bias plate do ?
Click to expand...

when you push lever right across to the left stick is aligned with 1st and second,when pushed to the right reverse and 5th, as there is no gate ,bias springs ensure 3rd 4th alignment
 
rip out your centre console, get to the top of the gearbox where your main lever goes in. change bias plate for a new one. adjust... easy £7 fix!
 
Ok well decided to have a go at the bias plate and springs today, and it was the bias plate that had snapped but i fitted new springs as i had them. its a bit fiddly getting the springs in place as you cant get it over the gear lever after its around the bolt, so you have to bend the short bit and insert the bolt while holding the tension of the spring lol but really anybody can do this job with a basic tool kit. so if your thinking of doing yours just go for it
 
The V8 man said:
Ok well decided to have a go at the bias plate and springs today, and it was the bias plate that had snapped but i fitted new springs as i had them. its a bit fiddly getting the springs in place as you cant get it over the gear lever after its around the bolt, so you have to bend the short bit and insert the bolt while holding the tension of the spring lol but really anybody can do this job with a basic tool kit. so if your thinking of doing yours just go for it
Click to expand...

or use mole grips to bend long part of spring around lever:)
 
jamesmartin said:
or use mole grips to bend long part of spring around lever:)
Click to expand...
I tried that first but the long part of the spring is too long to do it that way so i just used a pair of pliers and twisted the spring at the base till it lined up with the bolt hole it wasnt to hard to do just a bit fiddly.
Drove it yesterday and what a differnce it makes lol
 
You must log in or register to reply here.

Similar threads

moorsman61
Rear shock
Replies
7
Views
659
300bhp/ton
300bhp/ton
T
Rear spring stuck in upper seat
Replies
12
Views
439
Twinnie
T
mad85
Disco 2 Front hub/axle seal leaking
Replies
19
Views
1K
mad85
mad85
K
Disco 4 (LR4) xenon lights
Replies
0
Views
419
kiven
K
D1Nut
D1 300 tdi g/box out
2
Replies
23
Views
2K
D1Nut
D1Nut
Back
Top