Diesel on me dipstick !

Interceptorxj said:

Check your engine number stamped on the left hand side of the block below the exhaust manifold, it will start with 10P, 15P or even possible even 16 or 18

Click to expand...

adam koronka said:

Hi, my oil level seems to be creeping up. 2000 TD 5. I have bought a new and genuine set of injector seals - but I may have to suffer a new head. Some questions. I think my replacement engine is a 15p, how can I tell? Are the 10's and the 15's the same head - if I have to replace it. How can I tell visually if the head is cracked once the injectors are out? The car runs fine, went through emissions fine, doesn't smoke, the problem is purely that the oil level on the dipstick is rising - and the oil I suspect is thinning.

Also - I am not the strongest of people - would I need an engine crane to lift off and on the head?

Many thanks in advance

Adam

Click to expand...

adam koronka said:

Hi, my oil level seems to be creeping up. 2000 TD 5. I have bought a new and genuine set of injector seals - but I may have to suffer a new head. Some questions. I think my replacement engine is a 15p, how can I tell? Are the 10's and the 15's the same head - if I have to replace it. How can I tell visually if the head is cracked once the injectors are out? The car runs fine, went through emissions fine, doesn't smoke, the problem is purely that the oil level on the dipstick is rising - and the oil I suspect is thinning.

Also - I am not the strongest of people - would I need an engine crane to lift off and on the head?

Many thanks in advance

Adam

Click to expand...

Stanleysteamer said:

You will need a winch or crane to lift the head, even if you are strong enough it is just better to have more control over it, especially when putting it back on. Unless you have a mate who can help you, but even then.........

Click to expand...

Hellastony said:

A crane certainly might give you more control, but it can be removed and replaced easily by two people, and SWMBO was the extra two hands when I did mine!!!

Click to expand...

ronsealdeath said:

15p also has egr cooler at the front.

Click to expand...

Landmark2 said:

A 15p will have a fuel pipe from the front of the head to the FPR.
http://new.lrcat.com/#!/1232/37503/37504/2891
Griff

Click to expand...

Kenbo said:

Presumably you're going to try the seals first, plus the other checks mentioned? I'd like to be sure it's the head before pulling it off.

Click to expand...

Interceptorxj said:

Not if it has had a full EGR removal.

Click to expand...

Interceptorxj said:

Not if it has had a full EGR removal.

Click to expand...

ronsealdeath said:

15p also has egr cooler at the front. You may detect a crack if you take the rocker cover off, remove injector loom and rocker shaft, then turn the ign to II so it pressurises the fuel rail. You might see the leak. It could be an injector if your lucky. If you see a leak near an injector, swap it for another and see if the leak follows it.

Click to expand...