Cv bolts

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.


New Member
South Africa
Good day fellow landi owners....

I'm in need of some advice if possible...

I just replaced my baby's front drive shafts and im sitting with a question....

The spec for torque on the cv nut is 400nm but my torque wrench only goes to 210nm can sum one maybe say if I torque to 210 how many degrees can I add to get to 400nm?

The help would be much appreciated...

Greetings from South Africa....
It's difficult to work out the torque like that. Just do it as tight as you can measure, then a bit more (one flat) with an extension on a breaker bar.
How much do you weigh?
400nm is a nearly 300ft/lbs.

So not hard to get it with a mans weight and a breaker bar.