jakeslandy
Active Member
- Posts
- 237
- Location
- Bury St. Edmunds
Put the rear seats in. Took a little customising. But there in.
Complete Overhaul
- Thread starter jakeslandy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Put the rear seats in. Took a little customising. But there in.
jakeslandy
Active Member
- Posts
- 237
- Location
- Bury St. Edmunds
Need some advice. When I turn the ignition key to the start position I get this photo below. Please help..
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
have you got auxilliary (pos1)and ignition wire (pos2)mixed up on ignition switch
aaronmorris
Head's a shed
- Posts
- 6,369
- Location
- Doncaster
Isn't that normal?
Oil and battery light will go out when the engine is started.
Brake warning. Is the fluid low?
And glow plug light should go out on the timer.
Oil and battery light will go out when the engine is started.
Brake warning. Is the fluid low?
And glow plug light should go out on the timer.
jakeslandy
Active Member
- Posts
- 237
- Location
- Bury St. Edmunds
I get an audible click from the relay when it's turned over. But nothing.after.
I have tested the lines. Everything works properly. When I removed the steering column I didn't remove them from their original location. So should be good on that.
I have tested the lines. Everything works properly. When I removed the steering column I didn't remove them from their original location. So should be good on that.
jakeslandy
Active Member
- Posts
- 237
- Location
- Bury St. Edmunds
Oh and I'm trying to source some wheels from the states. If the company will reply. Aaron. I'll send you a pick. Much cheaper then here in England
jakeslandy
Active Member
- Posts
- 237
- Location
- Bury St. Edmunds
These are what I'm looking at
