The first question is 'why ?'
Rimmers are just resellers aren't they - whose CP wingtop protectors are you considering ?
2mm or 3mm
Aerial hole or not ?
Around the wingtop air vents or (those that fit) underneath them ?
Under the bonnet or just to the edge ?
Colour (Black or bare Alluminium) ?
Rolled to the headlight shroud join or stop short ?
Rolled edge to outer wing joint ot flat ?
3mm always. 2mm is to thin and flimsy
Aerial depends on if you have one. I do but in this day and age don’t use it as use my phone.
Around the vents. Under them doesn’t seal the vent loop properly
To the edge or under I didn’t know was a thing I thought it just depended on the alignment of the wing and the bonnet. One of mine is under one is to the edge! But the wings are not straight and the bonnet not square.
Colour is black. Silver reflects the sun and gives glare
Rolled to the headlight join to add rigidity
Never seen rolled to the outer wing thought they only did flat.