Hi , I've been trying to tighten down the injectors into my new head , managed two of them but the other two have a little play in them . Studs are fully in and the right way round ( I think ) with the flat bit at the bottom of the thread facing upwards . Clamps are installed curving downwards . Any ideas ?
Can't tighten down 300tdi injectors .
- Thread starter dogdog1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 7,877
- Location
- East Midlands
Good, glad that's sorted. Tried starting it up yet?
Funny you should say that , just tried it and of course no go . Any tips to get it going ?
tetsu0san
Active Member
- Posts
- 583
- Location
- Oxfordshire
I've never had to do anything to bleed the fuel system on either 200Tdi or a 300Tdi. Only ever had to keep cranking until the fuel filter is full then it'll start.
Marmaduke
Well-Known Member
- Posts
- 9,773
- Location
- Near the land of 'Me Duck'
Me to, I believe that they are self purging. Try it again but crank it for longer
