Disco 1 Camshaft

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi started stripping down to get to the cam everything was going fine until I got to the crankshaft spocket I used the puller which uses the 3 screw holes on the sprocket 2 hours later still the same any ideas much appreciated thanks
 
Silly question, but have you taken off the camshaft sprocket 1st? If you have then the crankshaft sprocket, timing chain and camshaft sprocket should come off together. The crankshaft sprocket is only held in its position with a keyway and should 'just' slide out.
 
Hi yes the cam sprocket first and then crankshaft damper came off ok but it’s the crankshaft sprocket behind the damper which is the problem thanks much appreciated
 
Its literally not held on with anything, the keyway just keeps it in the right position timing wise. Mine took a little wiggling to get it to come off but there's nothing holding it on to the shaft.
 
Disco 200tdi camshaft
Hi thanks for your response tried a bit of heat and plenty of wd40 and clean up the shaft and the laser puller still no joy
 
Counter intuitive, but it may be an idea to knock it back on. You've prolly got it just a teeny weeny bit askew. Invisible to the naked eye.
Never done this job on a D1, but I'd normally do it with two big screwdrivers or pry bars behind the sprocket, levering off the block, preferably spreading the load with bits of wood or summat. Never had a problem doing it that way.
 
You must log in or register to reply here.

Similar threads

NeoX
Discovery 5 DTC on camshaft sensor - timing chain replacement?
2
Replies
26
Views
2K
Hippo
Hippo
D
Camshalf oil leak
Replies
2
Views
464
discoverysean
D
Rich W
Disco 2 TD5 camshaft rotation torque
Replies
5
Views
625
Rich W
Rich W
S
camshaft installation
Replies
1
Views
437
steve2286w
steve2286w
N
freelander1 2002 td4
Replies
13
Views
784
J_D
J_D
Back
Top