Broke Bertie :( klunk then the propshaft and wheels stopped turning.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

cssbutler

Member
Posts
61
Hi Folks

Any clues on this one.... driving along normally, loud clunk then lost drive (in 2wd) propshaft and wheels stopped getting drive. Works ok if I engage 4WD (hi or low) but I think it's only driving the front wheels.
Put it back in 2WD no movement....

What have I broked this time ?

Series III 88"

Thanks in advance

Craig B
 
Probably a rear half shaft.
Jack a rear wheel up with front wheels chocked in 2wd with handbrake on wheel should not turn if it does pull the bolts out around the flange and pull the halfshaft out best do the offside / short one 1st as it is usually this one.More regular to shear at Diff end which entails removing the diff to get the broken piece out.
IMG_1484.JPG

IMG_1485.JPG
 
Thank you for the quick reply and detailed pictures.
Both my rear wheels are turning by hand, without the propshaft even trying to move.

Have it in 2wd with handbrake on and wheels chocked. Lifted one side at a time.

something to do with rear diff ??
 
If it is the diff end busted, try taking the opposite hub off and pushing a long pipe / rod/ broomhandle to push the broken bit through, sometimes works, sometimes dunt.
 
Thanks for your input guys... just had a butchers at it... and now feels like I won the lottory.
Short shaft is spinning on the drive member :)
Think I'll change both sides and drive members....
 
You cannot get a broom shank past the centre pin in the diff carrier to push snapped shaft end out of diff.Needs to be some thing thinner maybe a piece of 8mm dia bar.
A magnet pick up might also get snapped section out if it is in the diff end
Trouble with that though is any fragments of steel are in your oil so need cleaning out .
 
Its snapped at the diff end. There's a weak point where the shaft enters the diff. You'll have to jack up on the axles. Pull the half shafts to see which one is gone. Need to remove the diff as well and clear out the swarf and remove broken piece. New half shafts are £12.50 plus vat n carriage from Craddocks . You'll need a diff gasket and drive flange gaskets. 24 spline half shaft for S3, 10 spline for S2. It's a bit. Of a messy oily job but straightforward. You'll need a torque wrench n the settings are in the workshop manual. Good luck.
 
You must log in or register to reply here.

Similar threads

N
Wheel resistance
2
Replies
39
Views
3K
steve2286w
steve2286w
C
clutch problems after sitting in the weather for too long.
Replies
4
Views
520
cssbutler
C
ggrupea
Freelander 1 TD4 waterpump and other temp issues
Replies
1
Views
1K
GrumpyGel
GrumpyGel
G
Issue while turning
Replies
13
Views
990
lightning
lightning
G
Issues while turning at low speed
Replies
14
Views
915
Hippo
Hippo
Back
Top