Brakes non existent when engine is running.

Liverpool.90 · Jan 28, 2013

Hi all. Had a bit of a brown trouser moment tonight taking my defender out, pedal just goes to the floor and the brakes do nothing. Resistance builds when pumping the pedal with the engine off, but doesnt get truly hard. When the engine starts the pedal goes down, but while running the brakes do nothing.

Any ideas of what i should be checking? Is it likely that the system just needs a good bleeding, or does it sound like a more expensive job?

Thanks,
Ben

Soloby Rob · Jan 28, 2013

Master cylinder would be my first call.

Freelaner · Jan 28, 2013

Loss of servo assistance could be leak on the servo unit

Liverpool.90 · Jan 28, 2013

If it was the servo or master cylinder would i be able to spot a leak, or anything i could do to test and make sure thats what it is? Or is it just a case of replace the cheapest one first and hope that does it?

Thanks

Soloby Rob · Jan 28, 2013

Loss of servo assistance would give you a very heavy but full brake pedal, master cylinder internal seals often fail and give the symptoms you describe without any visible fluid leak.

Liverpool.90 · Jan 28, 2013

Ok, cheers for that rob, looks like im going shopping tomorrow.

warrior · Jan 28, 2013

Maybe a wheel bearing, this happened to me, brake pedal just hit the floor bearing was very loose.

Defender Bits · Jan 30, 2013

warrior said:
Maybe a wheel bearing, this happened to me, brake pedal just hit the floor bearing was very loose.

That's an interesting one, I guess the disc was moving about so much it pushed the pads right back! Worth checking and then almost certainly a master cylinder, I had similar on my old 90 and there was no leak just the master cylinder seals failed and so pushing past the fluid but none made it out.

warrior · Jan 30, 2013

Defender Bits said:
That's an interesting one, I guess the disc was moving about so much it pushed the pads right back! Worth checking and then almost certainly a master cylinder, I had similar on my old 90 and there was no leak just the master cylinder seals failed and so pushing past the fluid but none made it out.

If I pumped the pedel say twice it went solid as it should do, also if I turned one way gently and applied the brake and loaded the loose bearing I got no travel on my pedel.

Brakes non existent when engine is running.

Liverpool.90

Active Member

Soloby Rob

Banned

Freelaner

Landy Driver

Liverpool.90

Active Member

Soloby Rob

Banned

Liverpool.90

Active Member

warrior

Well-Known Member

Defender Bits

Banned

warrior

Well-Known Member

Similar threads