bosh ve pump
- Thread starter stooly
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
danny6801
Well-Known Member
- Posts
- 1,665
- Location
- North Wales
Could you possibly have an air lock
Did you take the pump off of the engine to do it or was it done in-situ? Did it all seem to go as planned or did you have any issues getting the distributor head off/on? Like dannys says it could be an airlock as the pump would have drained out. Have you tried disconnecting the pipes at the injectors and given it a good crank?
stooly
New Member
- Posts
- 6
Yes I tried that and no fuel coming up..
Did you take the pump off of the engine?
Have you got the DTI adaptor that goes in the central bolt hole? That will tell you if the pump plunger is turning when you turn the engine over. If it doesn't then you have either lost drive to the pump (hence the removed / insitu question) or something has come adrift inside it and you need to open it up again.
stooly
New Member
- Posts
- 6
No but I ordered the 12 piece timing kit which I believe has 1 as going to remove the pump next.. yes I am thinking some thing has come adrift when I did it as no other explination I can think of
biketeacherdave
Well-Known Member
- Posts
- 4,885
- Location
- south east london
If you removed the injector head completely without securing the internal pin then I suspect your pump is now scrap. I have a how guide on these for resealing.
