fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
As I'm on a budget of £0,what are the best realy cheap,or cost nothing mods you can do to a TD4??
Thanks
Thanks
Best cheap mods!!??
- Thread starter fishlander
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dougden
Active Member
- Posts
- 440
- Location
- North Kent
ebay .99p
Singvogel
Well-Known Member
- Posts
- 2,971
1. Pull the braid vacuum pipe off the EGR and stick a golf tee in the end of it. Result de-activated EGR.
2. Use a length of closed-cell foam to insulate the cool feed pipe from the A/C compressor to the bulkhead. Improves the efficiency of the A/C by reducing the heat the pipe picks up by being routed close to the hot return pipe.
3. Tape over the holes in the slam panel on either side of the bonnet catch and beside the headlights. Stops crud getting into the engine bay and increases the air-flow through the radiator.
4. Jam a piece of closed-cell foam behind the left hand turbo-pipe where there is a screw-head that can rub a hole in the pipe.
2. Use a length of closed-cell foam to insulate the cool feed pipe from the A/C compressor to the bulkhead. Improves the efficiency of the A/C by reducing the heat the pipe picks up by being routed close to the hot return pipe.
3. Tape over the holes in the slam panel on either side of the bonnet catch and beside the headlights. Stops crud getting into the engine bay and increases the air-flow through the radiator.
4. Jam a piece of closed-cell foam behind the left hand turbo-pipe where there is a screw-head that can rub a hole in the pipe.
200tdi ayre
Well-Known Member
- Posts
- 5,832
- Location
- Ashbourne (sometimes)
£5 worth of petrol and a match ?
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
1. Pull the braid vacuum pipe off the EGR and stick a golf tee in the end of it. Result de-activated EGR.
2. Use a length of closed-cell foam to insulate the cool feed pipe from the A/C compressor to the bulkhead. Improves the efficiency of the A/C by reducing the heat the pipe picks up by being routed close to the hot return pipe.
3. Tape over the holes in the slam panel on either side of the bonnet catch and beside the headlights. Stops crud getting into the engine bay and increases the air-flow through the radiator.
4. Jam a piece of closed-cell foam behind the left hand turbo-pipe where there is a screw-head that can rub a hole in the pipe.
Thanks mate,done 1 and 4 and I don't have AC!!
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
Great idea for a defender.
Dougden
Active Member
- Posts
- 440
- Location
- North Kent
Already have a better one!!!
Yes not surprised. My very poor attempt at humour. However, I do have one of these left over from fitting in mine. Looks good above the rear window and connects to the boot light. If you want it, PM me your address and I will post it to you. Otherwise it will probably be binned!
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
Yes not surprised. My very poor attempt at humour. However, I do have one of these left over from fitting in mine. Looks good above the rear window and connects to the boot light. If you want it, PM me your address and I will post it to you. Otherwise it will probably be binned!
What sort of light is it mate??
Dougden
Active Member
- Posts
- 440
- Location
- North Kent
The 15 small squares are LED's - I have put 5 in mine. Two under the dash, two under the rear seats and one on the roof above the rear window(inside the car obviously) All fed from the rear boot light.
A few on here have fitted similar and I think they are available in Maplins.
A few on here have fitted similar and I think they are available in Maplins.
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
Oh ok,does it make the boot any brighter at night??
Dougden
Active Member
- Posts
- 440
- Location
- North Kent
fishlander
Active Member
- Posts
- 437
- Location
- Taunton Somerset
Considerably.....
In that case then thankyou very much for your kind offer.I will send you a pm tomorrow mate,as I'm off in a min.
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
Soft top off eBay
love the softop
plus like them lights, think i will have to get some as well as the boot light is crap
plus fishlander have u tried the recycle site there is often bits for freelanders etc and just have to pay the p and p
I'm only on dla and know the feeling , would love to do alot more to the hippo but simply cant afford it.
hope things improve soon for u mate and sorry to hear about the work situation, not fun
hope this hasn't come across as disrespectful in any way
gary
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
that looks really good with the softop
hopefully may be able to invest in , well one day as i think there something completely different
bet i would have a heart attack if i went down the local stealers, lol
ebay for me
have u got any more close up pics of the softop please so can see it in full details
also been trying to find them lights but not on maplin etc, u would still have the code etc would u please , thks
gary
hopefully may be able to invest in , well one day as i think there something completely different
bet i would have a heart attack if i went down the local stealers, lol
ebay for me
have u got any more close up pics of the softop please so can see it in full details
also been trying to find them lights but not on maplin etc, u would still have the code etc would u please , thks
gary
Dougden
Active Member
- Posts
- 440
- Location
- North Kent
My son got them for me as he works in retail shop fitting. Sorry but I cannot get any more. Maplins was a guess as they have a lot of electrical items that can be adapted for cars.
Try eBay as I have seen similar 12v strips on there. Might be worth doing a search on here as well, as this has been covered earlier this year/end 2012?
Try eBay as I have seen similar 12v strips on there. Might be worth doing a search on here as well, as this has been covered earlier this year/end 2012?
