Bearmach galv roof rack

S

Stationwagon

New Member

Posts

3

• Jun 30, 2015

• #1

Hi.
Am new to site so hope I am putting question in right place? Just acquired full length galvanised roof rack from Bearmach for my 110. Surprised to find it was not supplied with rubber feet to avoid metal-to-metal contact. Spoke to their spares department and they don't appear to supply anything like that.
Has anyone got any advice on how best to fit roof rack without causing lasting damage?
Thanks, Andrew

 

Shifty1962

Well-Known Member

Posts

4,209

Location

The Winchester Club - Englandshire

• Jun 30, 2015

• #2

I cut up a plastic milk botle to make pads between the rack and the gutter.

 

S

Stationwagon

New Member

Posts

3

• Jun 30, 2015

• #3

Thanks! Helps with recycling too!!! Assuming single thickness is enough? And did you do same between clamp and underside of gutter? Andrew

 

Shifty1962

Well-Known Member

Posts

4,209

Location

The Winchester Club - Englandshire

• Jun 30, 2015

• #4

Stationwagon said:

Thanks! Helps with recycling too!!! Assuming single thickness is enough? And did you do same between clamp and underside of gutter? Andrew

Click to expand...

Yes I just cut pieces that folded under the rack and over the gutter so the clamps were also spaced off the gutter.
I'll take a picture later when it cools down if that helps?

 

S

Stationwagon

New Member

Posts

3

• Jun 30, 2015

• #5

Only if you have time - thanks.
Andrew

 

Jason2

Well-Known Member

Posts

2,001

Location

Poitou Charentes-France

• Jul 1, 2015

• #6

My 110 has got a big galva roofrack and the feet are metal to metal in the gutter. It's my daily work vehicle, get's loaded with anything from 10m beams to full camping kit for a family of 5 through the dessert twice and back and have never had a problem .