BATTERY
- Thread starter RizzleKicks
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve2286w
Well-Known Member
- Posts
- 4,523
- Location
- monkeyangerland
That’s a nice bit of kit, perhaps for home car charging could it be fitted to house facing south and run cables to where car parks, i think on cloudy days panels get about 10 % of rated output
RizzleKicks
Active Member
- Posts
- 254
Evening , came across the below , people’s thoughts or input plz
Wireless Car Battery Disconnect Cut Off Isolator Master Switch W/ Remote Control | eBay
1 Pcs Car Battery Isolator. (Battery Negative Column within 15-17mm). Connect the red wire to the positive pole of battery ，black wire to the negative pole of battery. Do not connect the positive and negative poles in reverse, or the motherboard may be burned.
www.ebay.co.uk
steve2286w
Well-Known Member
- Posts
- 4,523
- Location
- monkeyangerland
That looks clever and cheap as long as it dosent go like luton airport should do the trick, on my cousins MITO his earth battery clamp is a simple lever to disconnect quick and easy and helps when he’s away for a week, as long as no settings are lost , the current draw it uses should also be compared to what is drawn when it’s standing but looks like about 2amp over a Month
RizzleKicks
Active Member
- Posts
- 254
Yikes Luton airport 
, would rather have a non electrical device to do the job. Something that does not involve me popping open the bonnet everytime to deactivate the device. Steve do you have a pic or link to the one your cousin is using.
, would rather have a non electrical device to do the job. Something that does not involve me popping open the bonnet everytime to deactivate the device. Steve do you have a pic or link to the one your cousin is using.
steve2286w
Well-Known Member
- Posts
- 4,523
- Location
- monkeyangerland
Well this you have to pop bonnet of course , pic is similar to what he has, which was probably fitted as standard , don’t know if Halfords do something similar
RizzleKicks
Active Member
- Posts
- 254
, sure you only connect to the negative terminal
- Posts
- 2,061
- Location
- Hertfordshire
Hi Gary, hope you're keeping well. Battery wise (for the op) I fitted the one in the pic & it has been great. If I'm not using the D2 for a week I plug in my solar panel via the OBD port (both from Halfords) & stick said panel where the sun shines in the the most
. I also bench charge it every 6 months on my Ring intelligent charger for 24hrs. On the NOCO front I got the GB70 which I used a lot initially as the truck had a dodgy battery on it when I got it (as a lock down project in June 20) & I didn't want to splash out on a new battery until I knew where I stood with it, again the NOCO has been great to this day (not needed on the D2 obviously) on other vehicles as I always carry about with me, all the best.Attachments
Hi Gary, hope you're keeping well. Battery wise (for the op) I fitted the one in the pic & it has been great. If I'm not using the D2 for a week I plug in my solar panel via the OBD port (both from Halfords) & stick said panel where the sun shines in the the most
hi mate
not bad thks, hope ur also well
many thks ref the noco as been looking around for a jump pack so great getting feedback
hopedully my solar panel will be here next week, got the renogy one due to its good reputation, fingers crossed will just be enough to keep the battery topped up
thks again my friend
