Back door issues

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Stof2484

Member
Posts
25
Location
Sheffield
Help...

I have a freelander 1 2006 the back window drops but the door won't unlock and I don't have a key or barrel to open it any ideas what could be the issue and how do I get in it
 
So firstly, the tailgate key hole.only raises the window if it is down to save you opening the car again to shut it.

If the window drops when you open the door handle then the CCU is getting a command to operate the tailgate latch.

Most likely it is the motor in the tailgate latch that has failed or a broken wire in the hinge of the door.

Check circuits and confirm the door is getting a release voltage to the latch..check on the connector to the tailgate behind the rhs boot side panel.

If it is OK then you will have to remove the inner door cover and release the latch with a rod hooked to the end where the failed motor is attached. Looking at a picture of a latch assembly helps you locate the right spot.
 
Help...

I have a freelander 1 2006 the back window drops but the door won't unlock and I don't have a key or barrel to open it any ideas what could be the issue and how do I get in it
Personally I give the not right under the handle a good kick, that engages the servo that pulls the latch release and open the boot.

When you use the handle or button in the boot does it make an opening noise? Or is it silent?

Sometimes the hook that pulls the latch release falls off and can't open the boot, right pain to fix
 
So firstly, the tailgate key hole.only raises the window if it is down to save you opening the car again to shut it.

If the window drops when you open the door handle then the CCU is getting a command to operate the tailgate latch.

Most likely it is the motor in the tailgate latch that has failed or a broken wire in the hinge of the door.

Check circuits and confirm the door is getting a release voltage to the latch..check on the connector to the tailgate behind the rhs boot side panel.

If it is OK then you will have to remove the inner door cover and release the latch with a rod hooked to the end where the failed motor is attached. Looking at a picture of a latch assembly helps you locate the right spot.
Cheers mate ill have a look tomorrow evening see if I can get into it bloody nightmare worked 1 minute then stopped
 
Personally I give the not right under the handle a good kick, that engages the servo that pulls the latch release and open the boot.

When you use the handle or button in the boot does it make an opening noise? Or is it silent?

Sometimes the hook that pulls the latch release falls off and can't open the boot, right pain to fix
I can't hear the latch in any way but the window drops
 
This will help you

 
This will help you

Cheers mate ill have a look through and what I can fathom would chucking a 12v supply at it from inside help
 
This is what it all looks like inside the tail gate - when you get it open! There are 4 screws under the lower edge on the handle side of the tailgate. You can get to them by lying on the 'boot' floor... You have to carefully pull the sides off then lift the card upwards.
 

Attachments

  • IMG_4685 2.JPG
    IMG_4685 2.JPG
    165.7 KB · Views: 45
  • IMG_4689 2.JPG
    IMG_4689 2.JPG
    231.8 KB · Views: 45
  • IMG_4690 2.JPG
    IMG_4690 2.JPG
    226.1 KB · Views: 43
This is what it all looks like inside the tail gate - when you get it open! There are 4 screws under the lower edge on the handle side of the tailgate. You can get to them by lying on the 'boot' floor... You have to carefully pull the sides off then lift the card upwards.
Cheers mate was wondering if they where easy to get 2 as I can't get into the boot
 
Evening everyone

I have success changed lock and handle all working then stopped turns out someone had bodged the purple and blue wire in the door hinges and so it kept stopping working joined repaired all working again and lock working bettr than before
 
Back
Top