Back after 5 years EAS?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

sandyt

Well-Known Member
Posts
1,615
Location
Wraysbury Nr Heathrow
Hi all 5 years ago my p38 blew the head gasket (might have been my fault ) anyway I bought a supercharged l322 and have done over 130k in it since. Anyway a couple of months ago I went to the p38 fixed the head gasket and after 5 months off we go loads of stuff needed doing but all done and now MOT'd.
One last issue is the suspension. Replaced the bags as it had been sitting in the garden for 5 yrs now it holds up but when I start her up she raises about 25mm the pump runs pump stops there are about 3 clicks she vents a bit and relevels then goes through the sequence again anyone any ideas - was wondering if it was pressure sensor?
 
sandyt said:
Hi all 5 years ago my p38 blew the head gasket (might have been my fault ) anyway I bought a supercharged l322 and have done over 130k in it since. Anyway a couple of months ago I went to the p38 fixed the head gasket and after 5 months off we go loads of stuff needed doing but all done and now MOT'd.
One last issue is the suspension. Replaced the bags as it had been sitting in the garden for 5 yrs now it holds up but when I start her up she raises about 25mm the pump runs pump stops there are about 3 clicks she vents a bit and relevels then goes through the sequence again anyone any ideas - was wondering if it was pressure sensor?
Click to expand...
It needs to go on diagnostics, the pressure sensor is unlikely to be the problem. When you say "it holds up" does that mean it goes to normal height and stays there? Or is it only raising 25mm from the bump stops?
As it's been stood fore a long time, check and clean the connectors in the EAS box, do the same with the connectors for the height sensors for starters.
 
Yes it raises to normal height I did al the connections in the EAS box but didnt do the height sensors - I now don't have diagnostics for the p38 so need to buy some any recommendations (i have a 11D tool for the l322) .
 
sandyt said:
Yes it raises to normal height I did al the connections in the EAS box but didnt do the height sensors - I now don't have diagnostics for the p38 so need to buy some any recommendations (i have a 11D tool for the l322) .
Click to expand...
I can supply the RSW EAS software & cable or you can download the software free and make your own cable. Needs a Windows laptop.
If it raises to normal height with no faults, there cannot be much wrong. Do yo have the bonnet open when the cycling of the compressor occurs? If so, see if it's the same with the bonnet closed.
 
Its the same with the bonnet open and closed - Is there a cable and software that works on a Mac - I used to have all of it
On another note we were down in the Vendee earlier this month might need to pick your brains re info on weather for the region as we are looking to buy in France we have spent years and been all over and sort of narrowed it down to Dordogne or Vendee
 
sandyt said:
Its the same with the bonnet open and closed - Is there a cable and software that works on a Mac - I used to have all of it
On another note we were down in the Vendee earlier this month might need to pick your brains re info on weather for the region as we are looking to buy in France we have spent years and been all over and sort of narrowed it down to Dordogne or Vendee
Click to expand...

Think Mac works with the Windows emulator. Or there may well be a Nanocom near you as you're near Heathrow. @brianp38dse is down that way.
 
Sandy,
I'm in Langley just up the road from you. I assume if you got the MOT it's drivable ? If you want I can connect Nanocom over the weekend ?

PM me if you want to come over.

Pete
 
sandyt said:
Its the same with the bonnet open and closed - Is there a cable and software that works on a Mac - I used to have all of it
On another note we were down in the Vendee earlier this month might need to pick your brains re info on weather for the region as we are looking to buy in France we have spent years and been all over and sort of narrowed it down to Dordogne or Vendee
Click to expand...
It can be a lot hotter in summer and a lot colder in winter in the Dordogne than the Vendée. It depends where you go in the Vendée what the weather will be like. I'm biased, I like the Vienne, it usually has almost as much sun as the med but without the temperature extremes. I like the Dordogne, but judged it too far for regular trips to visit my kids in the UK. Not a good time to be thinking of moving here because of the Brexit uncertainty.
 
Hi..buy in France at the moment ? I received my letter from the u.k Govt.. yesterday...in the event of a no deal Brexit, health cover will only be guaranteed for 6 months...It seems to be chaos.
Regards
 
I agree with Data as far as the Vienne is concerned. More sun than most of the rest of the country, not as blisteringly hot as the Dordogne in summer, not as wet as the Vendee in winter. As a general rule keep south of the river Loire for better weather, and inland to escape the worst of the gales/storms.
The exchange rate is not good at the moment for transferring stirling, might be best to wait a year. If we had crystal balls life would be so much easier.
 
siddeley said:
Hi..buy in France at the moment ? I received my letter from the u.k Govt.. yesterday...in the event of a no deal Brexit, health cover will only be guaranteed for 6 months...It seems to be chaos.
Regards
Click to expand...
The UK government will do anything to get out of paying for health or pension increases for Expats, they need the cash to squander elsewhere like on illegal immigrants that have never paid and never will pay into the system:mad:
 
Fortunately for us we have no ties to England at all and I do hope it doesn't effect any of you who still do.. it's a bloody shambles imo..
 
Mark Piercy said:
Fortunately for us we have no ties to England at all and I do hope it doesn't effect any of you who still do.. it's a bloody shambles imo..
Click to expand...
Apart from grown up kids I have no ties with the UK other than my pension income.
If you have ever worked in the UK and paid NI, you will have residual pension rights for the future.
Rain seems to have stopped, so it's back to loading the caravan.
 
Datatek said:
Apart from grown up kids I have no ties with the UK other than my pension income.
If you have ever worked in the UK and paid NI, you will have residual pension rights for the future.
Rain seems to have stopped, so it's back to loading the caravan.
Click to expand...
It's going to throw it down here,it's looming in the air!
We've two older lads in England and my pension was frozen at the point of leaving and never heard from again??
Taking the transit with the caravan? Don't forget to leave a washing machine by the caravan when you park up!!
Proper gypo/traveller!!:p
 
Mark Piercy said:
It's going to throw it down here,it's looming in the air!
We've two older lads in England and my pension was frozen at the point of leaving and never heard from again??
Taking the transit with the caravan? Don't forget to leave a washing machine by the caravan when you park up!!
Proper gypo/traveller!!:p
Click to expand...
You can at the moment continue to make contributions to you UK state pension.
Got an old fridge, will that do instead of the washing machine?
 
You must log in or register to reply here.

Similar threads

MikeFl4
P38A Possible coolant in oil
Replies
9
Views
933
Datatek
Datatek
enjoi
P38A Going through radiators- not overheating
2 3 4
Replies
60
Views
4K
enjoi
enjoi
ukadamwest
P38A Farewell to another P38.. or hello ?
Replies
18
Views
2K
Grrrrrr
Grrrrrr
SuperDaz
Back again after 15 years
Replies
1
Views
542
brianp38dse
brianp38dse
stumpyj
(2000 TD5 90 defender)TD5 Fuel Pump
Replies
4
Views
335
stumpyj
stumpyj
Back
Top