Axle Stands

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

ChrisMidWales

Member
Posts
49
I have bought x4 3tonne axle stands so that I can start working safely on under my car. What I am struggling to find is information, especially a diagram, of where the safest place to put the stands.
Would someone be able to visually (sorry to be specific but I work best on visuals rather than written instructions) show me where these places are, presuming I would want to lift the whole car.
I don’t know if this would effect the answer but I own a FL1 53 plate pre-facelift Td4.

P.S I bought a 4 tonne bottle jack as it seemed the best idea for lifting my car on my drive which isn’t a lovely concrete drive. Does anyone have any feelings on this choice?

Thank you all.
 
Last edited:
RAVE is a good start.

1726735187411.png
 
  • Like
Reactions: hd3
Personally i would not use a bottle jack they are not secure enough, a good 3ton trolley jack with 4" jack plate is better, or 4 good ramps.

5QKpRIel.jpg
1

1wNNttPl.jpg
2

Jack up on the rear subframe chassis centre.
Q76z0ybl.jpg
3

Put axle stands where the jacking point is on the car.
qy7Egrzl.jpg
4

Wk7oit5l.jpg
5
 
I put the rear axle stands on the subframe as the jacking point is near to the corner that tends to turn into dust.
I did drive it onto ramps, then jack the rear up to put on axle stands. Never doing it again as when jacking it moved back slightly onto the ramp, then as I lifted the back off the stands it came down the ramp, quickly! Not in gear but handbrake on which did stop it.
The Halfords ramps advertise and reviews to match, good for lower vehicles. Which means the approach angle is less and easier to get up without the ramp moving.
 
J_D said:
I put the rear axle stands on the subframe as the jacking point is near to the corner that tends to turn into dust.
I did drive it onto ramps, then jack the rear up to put on axle stands. Never doing it again as when jacking it moved back slightly onto the ramp, then as I lifted the back off the stands it came down the ramp, quickly! Not in gear but handbrake on which did stop it.
The Halfords ramps advertise and reviews to match, good for lower vehicles. Which means the approach angle is less and easier to get up without the ramp moving.
Click to expand...
I have put all my cars on two ramps, the front always being longer under the wheel, and wood chocked to stop roll back when lifting the rear up to insert the rear ramps.

ky347fcl.jpg
1

5bpRHy4l.jpg
2

s8uIgHjl.jpg
3
 
  • Like
Reactions: J_D
You must log in or register to reply here.

Similar threads

Tirran
Axle Stands
2 3
Replies
40
Views
4K
miktdish
miktdish
proto57
Freelander 2 (LR2) Baffling (to me!) front Half-shaft/Axle Length Mystery! Too short, twice???
Replies
10
Views
858
Zorro587
Zorro587
M
Freelander 1 VCU off for car how to test
Replies
2
Views
300
GrumpyGel
GrumpyGel
G
propshaft fitting
Replies
6
Views
1K
GerryN
G
T
Defender front wheel not spinning.
Replies
2
Views
399
miktdish
miktdish
Back
Top