ARP head studs

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
wangie46

wangie46

Active Member
Posts
963
Location
Lakeside Essex
Ordered all the parts to rebuild my 4.0 and went with arp head studs, my question to you knowledgable chaps is do I locktight these into the block or not?
 
Is it not just the normal torque to a figure, then tighten 90 degress then a further 90 degrees? Or something similar.

I would say using threadlock on head bolts is a definite no no.
 
you can loctite a stud but not a bolt ,but it isnt necessary ,loctite is to stop a fastening coming loose the stretch on head bolt is more than enough
 
you can reuse arp..so cant be stretch..nought wrong with loctite.DONT use much though.you dont want it on head where gasket goes.
 
after locktighting my arp main stud kit never again

if you speak to realsteel they say just put them in hand tight so thats what i have done on the headstud kit
 
####s up the ally threads tryna get em out if u need to I guess? and it says in the instructions with the kit you dont need to. You will have to ask em lol.

to the op i did mine in 3 equalish stages to 80 ftlbs
 
I noticed a couple of mine turned a little more on the final torquing but I guess the stud was just going in to the block a little more before it settled
 
You must log in or register to reply here.

Similar threads

A
P38A Head Gasket Kit & ARP Bolts ?
2
Replies
23
Views
1K
enjoi
enjoi
Wilson90
Wolf Door Top parts
Replies
6
Views
448
dag019
dag019
spins
Cylinder Head Overhaul
Replies
6
Views
635
steve2286w
steve2286w
A
P38A Broken oil dip stick tube removal
Replies
3
Views
302
AndyF07
A
Gorf
5.0 SC rebuild
Replies
6
Views
1K
marjon
marjon
Back
Top