GDM
Active Member
- Posts
- 205
- Location
- West Sussex
I got the air springs fitted yesterday, and I have to say it was a far easier job than I thought it would be.
It took me a few hours in total but mostly because I also changed the rear shocks, cleaned off the area of chassis behind the air springs, applied Kurust and 2 coats of underseal.
I fitted the Dunlop springs and I was a bit dubious about having to chop off the original connector on the end of the pipes but the push-fit connectors seem to have worked fine.
I attempted to re-inflate the system this morning, for which I left the chassis propped on axle stands, with a trolley jack under the rear diff, so that I could check that the springs inflated properly. I was slightly perplexed when after several short bursts with the engine running they hadn't inflated, then I remembered that to use the high suspension setting all the doors must be shut, so I got in and shut the door and the springs inflated straight away.
Been busy with the family most of today but hopefully I should get it back on its rear wheels later tomorrow, then I can tackle the front shocks and EGR by-pass.
It took me a few hours in total but mostly because I also changed the rear shocks, cleaned off the area of chassis behind the air springs, applied Kurust and 2 coats of underseal.
I fitted the Dunlop springs and I was a bit dubious about having to chop off the original connector on the end of the pipes but the push-fit connectors seem to have worked fine.
I attempted to re-inflate the system this morning, for which I left the chassis propped on axle stands, with a trolley jack under the rear diff, so that I could check that the springs inflated properly. I was slightly perplexed when after several short bursts with the engine running they hadn't inflated, then I remembered that to use the high suspension setting all the doors must be shut, so I got in and shut the door and the springs inflated straight away.
Been busy with the family most of today but hopefully I should get it back on its rear wheels later tomorrow, then I can tackle the front shocks and EGR by-pass.