Disco 2 ACE error 33
- Thread starter MJI
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
Which scanner?
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
Might be a bad contact on that DCVs circuit
thanks , I hope it is a one off, as last time I had troubles it was new ECU time.
Just worried it could be a failing solenoid as I have no alternative ones, mine is the later type as also fitted to the Discovery3 Range Rover alikes.
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
Usually if the solenoid fails it's not intetmittent, your problem is more likely a bad contact on the circuit IMO, can be in C0377/0391(big orange plug near the fusebox in engine bay) or in the solenoid's plug unless the wiring is chafed somewhere
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
Oooops, that solenoid doesnt look good at all, might be corrosion in it's connector or the winding's connections to the pins are affected... yes, better replace it to be ruled out
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
you know that the PCV on the side is different than the DCVs dont you? too bad that you have the late modell block cos the solenoids for the early ones like mine are around £50 a piece... i'm wondering how much different they are though
End is more expensive as well.
And they are totally different, old ones have a screw cap and smaller bore.
Similar threads
Disco 2
ACE Fault
