A Frame Balljoint - Lining bolts up on replacing

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
B

Baker556

Member
Posts
68
Hi all,

Swapping out the A-Frame balljoint on my disco 200tdi - I thought removing would always be the major problem here but when it comes to refitting the bolts are struggling to line up and slide in.

In regard to bolts these are the ones sliding into the top of the new a frame balljoint, the two 19mm, I just cannot line them up, any tips or tricks? Is worth getting the car jacked up?

Thanks
 
Top Tips guys thanks alot - I did insert a very long screwdriver, but even then one side was so difficult to line up and when the bolt started to get through it dropped :(

For anyone else having completed the same, pls keep the ideas rolling in.
 
Baker556 said:
Top Tips guys thanks alot - I did insert a very long screwdriver, but even then one side was so difficult to line up and when the bolt started to get through it dropped :(

For anyone else having completed the same, pls keep the ideas rolling in.
Click to expand...
Small scissor jack or even a ball joint remover or summat that can be wound in or out via a bolt? Maybe make up a special tool?
But yes, judicious use of jacks and blocks of wood, why not?
 
Never done this job so don't know, but if there are two bolts to go in, in roughly at least the same plane, then can you not use one of the tools mentioned to line up one set of holes and then get a bolt in the other pair?
If all else fails is there any mileage in taking it all apart, bolting up loosely the difficult ones then reassembling?
Basic rule obvs is never tighten anything up until all the bolts and nuts are on.
 
have you fitted the ball joint to the axle?

Id bolt it to the arms first :) It should not be dificult as there nothing under tension then.
 
@EeEk tried both ways still having difficulty it's almost like there is tension on one of the arms not making it square.

The disco is on the ground without jacks.
 
That's brave having no jack under there, nothing to stop the axle rotating. Get the chassis picked up a bit and supported, as mentioned above fit the balljoint bracket to the arms first
 
You must log in or register to reply here.

Similar threads

Rubberknees
P38 rear door window trims replacement
Replies
14
Views
1K
Rubberknees
Rubberknees
jimllshiftit
Any advice for novice welder about to stitch new rear cross member to 90 chassis?
Replies
3
Views
788
tottot
tottot
xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
359
xDParis64
xDParis64
J
300 Tdi engine swap story - and a few questions
Replies
13
Views
2K
doriz
doriz
mick 1986
Salisbury to A frame balljoint bolts
Replies
17
Views
2K
Cavey_P38
Cavey_P38
Back
Top