200tdi without heater plugs as standard?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Steviefd

Steviefd

New Member
Posts
29
Location
north wales
A warm hello to you all, ( from a damp Wales)

I would like to know if any 200tdi 90's were made without heater plugs/glowplugs as standard? Or was it a common modification done to GPO vehicles?
We have an ex postoffice J reg 200tdi 90, new to us, and it has no heater plugs/glow plugs.

I have searched for info however the massive amount of info I have read has not answered the question.

Basically we are wondering if something is amiss or if our new trusty ex GPO is as God intended.

Many thanks,
Steve
 
never seen a tdi head with no glow plugs ,often there not wired up if truck has been converted to tdi ,they will start without them except for perhaps extreme cold
 
thankyou very much James you are a gent. It is kept in on the valley bottom of quite a cold area that is mainly in the shade this time of year and frost often doesnt get chance to thaw during the day, so the landy is often frozen for days at a time. I will monitor its starting performance as time goes by.

Many thanks once again for your time.

Steve
 
there will be plugs in the head (below injectors )or a place to put them ,wiring a switch and relay can be simple ,have a look
 
I'm intrigued. I've had my '92 110 tdi 200 from new and unlike the series III it replaced it doesn't seem to need to turn the key and hold it until the glow plug light goes out as with earleir models. I've always assumed it didn't have glow plugs.
 
Birdbrain said:
I'm intrigued. I've had my '92 110 tdi 200 from new and unlike the series III it replaced it doesn't seem to need to turn the key and hold it until the glow plug light goes out as with earleir models. I've always assumed it didn't have glow plugs.
Click to expand...
later models use a timer relay instead which comes on with ignition so no need of holding key at that position before cranking
 
Just learnt something new! Checked the orignal owners manual and it does have glow plugs. Ignition on to position II for a few seconds and little orange lamp on display should come on for a few seconds. Never knew that.......
 
You must log in or register to reply here.

Similar threads

A
P38A Heater matrix o-ring / pipes - advice needed !
2
Replies
23
Views
2K
romanrob
R
J
P38 2.5 dhse - strange starting issue only every 3 starts
2
Replies
29
Views
3K
Datatek
Datatek
Goc3k
Discovery 1 SOLD 1997 300TDI manual D1, Winchester
Replies
16
Views
4K
Goc3k
Goc3k
Blob
L322 (Not your usual) battery drain
Replies
7
Views
2K
Datatek
Datatek
dag019
Identifying wiring connectors and colours
Replies
6
Views
1K
dag019
dag019
Back
Top