200tdi 90 rear exhaust hanger

109inches · Nov 12, 2015

When i replaced my rear crossmember on the 90 it had a bracket sticking out the crossmember on the exhaust side with nothing more than a hole in it.

When I bought the Land Rover the rear crossmember had turned to dust and the rear silencer portion of the exhaust didn't exist. So has anyone got a picture of how the rear part of the exhaust joins to this flat piece of metal coming off the crossmember. A Google search has proved ineffective.

ER1C · Nov 12, 2015

Was that not the mudflap bracket ?

109inches · Nov 12, 2015

No it comes of 90 degrees pointing toward the back of the rear wheel with nothing but an oval hole in it. There isn't one on the drivers side of the crossmember

gse1986 · Nov 12, 2015

Presuming it's a tdi and not a TD, i think it's ESR95 you're after

flat · Nov 12, 2015

It's just a flat bit of metal and an exhaust hanger poking off of it - will take a photo in the next day or so

ER1C · Nov 13, 2015

So to answer your question, if the above is the item ESR95 (nice one GSE1986), which I assume it is...

There is a normal bog standard exhaust rubber ; NTC5582

Which slips over the right side of this item and the other hole in the rubber slips over your exhaust bracket.

zeaphod · Nov 13, 2015

The earlier ones have a different setup - plate with a hole at the chassis and a plate welded to the rear silencer. You then use the collection of nuts/bolts/rubbers to make up the mounting

zeaphod · Nov 13, 2015

Depends what is on the exhaust - hook for hanger or hole for bolt?

200tdi 90 rear exhaust hanger

109inches

Well-Known Member

ER1C

Well-Known Member

109inches

Well-Known Member

gse1986

Active Member

flat

Well-Known Member

ER1C

Well-Known Member

zeaphod

Well-Known Member

zeaphod

Well-Known Member

Similar threads