2 inch lift kit

Toseland · Apr 25, 2018

Want to fit a 2inch spring lift kit (spacers) to aid a few of my local pay and play sites.

I intend to leave the SLS intact, but a quick question before I break out the trig and calculate it.
how long does the SLS sensor extension bar need to be?

brian47 · Apr 25, 2018

There's no need to break out the trig tables. A full lift kit for the D2 with SLS is available, containing the adapters for both front and rear springs and the adapter plates for the ride height sensors to bring the SLABS ECU back into normal calibration.
For example:-
https://www.ebay.co.uk/itm/Land-Rov...196739?hash=item3373352c83:g:WdwAAOSwU91aU3Oc

It might also be worth you having a read of the post by @300bhp/ton about the problems which you might encounter in your quest for altitude:-

https://www.landyzone.co.uk/land-rover/lifting-a-d2-properly.300573/#post-3749057

Toseland · Apr 25, 2018

Yeah I am getting a Dixon fab one, it doesn't come with the sls sensor adjustment, hence I was asking

brian47 · Apr 25, 2018

@Toseland, if you take a look at the ebay advert you'll see two plates with two holes in each. I would sugest that they would be installed securely to the mounting holes where the ride height sensors are currently fitted to the radius arms and the sensors are then fastened to the other end. I would suggest that the distance between the hole centres in the plates is the same as the lift being fitted, in the case of the advert, 40 mm.

That would effectively increase the distance between the old and new mounting points for the ride height sensors by the required amount. Looking at the drawing, I can't see any way that the adapter plate could move or rotate around the mounting bolt used to attach it to the radius arm:-

Toseland · Apr 25, 2018

i cant see how raising the springs 2 inches would give an equal 2inches of movement in the sensors,

even basic calculations suggest that if the arms are half way down the arms, 2inches of lift then the distance moved would be 50%, 1 inch..

Toseland · Apr 25, 2018

just went to do some measuring..

880mm approx from centre of the axle to the centre of the bush on the chassis,
480mm approx from the bush to the SLS height sensor.

by my calculations, a 50mm lift will need a 27mm spacer, (50/880*480),

brian47 · Apr 25, 2018

You could do it by a "trial and error" type method.

Measure the distance between the sensor mounting hole on the radius arm to a point directly above it on the chassis.
Install your suspension lift blocks.
Re-measure the distance as in 1 above.
The measurement in 3 minus the measurement in 1 should then give you the distance between the holes in the required adapter plates.

At least it will save you having to fry your brain trying to work things out on paper.

Toseland · Apr 25, 2018

saying that yeah i could..

is the SLS manual raise function 40 or 50mm?

brian47 · Apr 25, 2018

All that's quoted in the Owner's Handbook is 40 mm (approx).
Given that it does add the "approx." I wouldn't trust it for making any definitive measurements.

Vincemcdonald · Apr 25, 2018

I lifted my old D1 with spacers. Worked fine. But needed to buy +2” rear shock as the originals topped out and had to refit the rear ARB using tow bar spacers.

2 inch lift kit

Toseland

Active Member

brian47

Well-Known Member

Toseland

Active Member

brian47

Well-Known Member

Toseland

Active Member

Toseland

Active Member

brian47

Well-Known Member

Toseland

Active Member

brian47

Well-Known Member

Vincemcdonald

Active Member

Similar threads